20 Most Recent
2008 Mazda B-Series Truck Questions & Answers
My 1998 Mazda b2500 won't
with a manual tranny, the most likely cause for problems going into gear is the synchronizers, as long as it is just the synchros, a rebuild on bearings and synchros is not to terrible.
Please describe cylinder head
The head torquing sequence is as below:-
9....5....1....3....7
Front
10...6....2....4....8
Carry out the sequence at least three times, once at about half the torque value and then at least twice at the full value.
I have an 86t b2000
The choke wire plugs into the back of the alternator. Did you put the head back on with the engine at TDC? Have you checked the ignition timing?
I have just rebuilt a
how are you priming the system
before installing the oil pump , you fill it with grease or vaseline
That primes the pump so that when you start cranking it it is producing pressure
to get pressure you need volume and there will be no way that you will get the volume required other than by the pump
1987 b2200 no spark
Pick up point on magneto? Or faulty coil earth? Not sure if these have cdi some time cause
How to give my engine back its power
Step 1. Make sure your cat converter is not blocked up.drop exhaust in front of cat (yes it will be loud) take a ride around the block. If it runs better get a new hiflow cat. If not it could be bad injectors. Do a compression test on all cylinders.
Diesel loss of power
check and change the fuel filters including the water filter.. If you are using a bio diesel then don't. Check and bleed any air out of the pump and lines. check that the air valve on top of the tank is clean and allowing the tank to vent and not get a vacuum. Check for a moss like substance in the tank as it will seriously affect the diesel and injectors. Basically It sounds as if the pump is starving for fuel from a blockage or air in the system.
1998 mazda b2500
maybe you thermostat is not working properly. if the water from the hose is flowing through your cooling system freely that tells me your thermostat is wide open
Cant find torque settings for a mazda XA 3.0L 4 cylider
older mazda diesels e3000 (3litre) were often rebadged to ford traders I have a book on that diesel (E3000)and if it is the same I can give you the specs but to find you again I will require you to send a reply comment. It may take me some time to dig up the book so if you will reply comment I will send you what I have
Mazda temperature gauge
When the gauge doesn't work, you have to determine, is it the gauge on the dash or the temperature sending unit on the engine or a wiring problem. Try this: find the sending unit on the engine and pull the wire off it. With the ignition key on, touch the wire to a metal ground on the engine. Does the temp. gauge move? If it does, replace the sending unit. If it doesn't move, replace the temperature gauge on the instrument panel.
Windows will not go up or down
If this is a sudden problem and both or all windows are affected...check relays and fuses. If only not working from driver door check switches to see if came unplugged.
Not finding what you are looking for?