2009 Hyundai Elantra - Answered Questions & Fixed issues

Question edited for clarity, typos and punctuation. Question moved to model category. Did you know there is a recall on the subframe and also a class action law suit? https://www.google.com/search?q=2009+hyundai+elantra+subframe+recall Limited replacement help but there is a video on the Accent. https://www.google.com/search?q=2009+hyundai+elantra+front+subframe+replacement ..

Most likely #1 fuel injector is dirty or defective causing a lean condition on # 1 cylinder.

sounds like a failing rubber insulator take it to a front end specialist shop for a detailed inspection

if the car has a fold down back seat fold it down and try to reach in the trunk there should be a safety pull to open it or if you can reach the keys you are done ! if it does not have a fold down seat the fastest and safest way is call a locksmith or AAA if you have the service you dont want to start using a coat hanger or a slimjim on that car you could break the plastic clips that hold the linkage rods in place in the door and do some damage to the car . hope this helps

The thrall bearing may be worn out. It sits on the clutch fork. When you step on the pedal, the fork pulls the bearing away from the clutch "fingers", taking the load off the thrall bearing.

Only the 2009 Hyundai Elantra Touring has a USB port.

you will have to call the dealer or see if the place you bought it from has the code or find it the in with the car manual. sorry, good luck

Damaged seatbelt replace

If it as a self adjusted Polly. No need to adjusted. If it dost is normally on you alternator.

The locking trigger may be too close to the ratchet teeth.

Here's a video on your brakes. DIY 09 12 Hyundai Elantra Front Brake Pads Bundys Garage

Hi Michael, Thats a sign that you need to have the transmission repaired. You need to replace parts like release bearing, pressure plate and clutch disc. This parts causes the slipping and chugging. Thank you! If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

The rear wiper motor is separate from the front one. That is right behind the back door panel at pivot point. Your wiper motor and pump for your front washer fluid is under the grill below your pivot points on the front wipers.

Hello, Try removing and cleaning both battery terminals with a wire brush.

Please look at your Owner's manual. It details location of the fuse box and the fuse for the brake system. If your brake lights don't work it may be something other than a fuse. If you don't have an Owner's manual try this http://www.manualslib.com/

Temporarily disconnect the horn and consult a Professional key programmer.

I would start by having someone who has a little electric knowledge to look for a loose wire. I would start with the ground wire. maybe it just never got tightened down right at the factory or over the years electricity can build up some erosion.

Bring it to a junkyard and they will tell you.

Hi don.. According to positive reviews (for the seller), these one leads Sylvania 9006 SU SilverStar Ultra Halogen Headlight Bulb Low Beam Pack of 2 (+affordable price) I hope it was helpful. Enjoy

Find your fuse panel and check your fuses Your flasher mechanism under your dash may need replacing as well.