2009 Honda Odyssey - Answered Questions & Fixed issues

You need to get it scanned with a diagnostic scanner to check for transmission error codes.

It won't open?

The door locks are controlled through the vehicles body control module is my understanding, so what needs to be done is to have the BCM scanned and an active test run to see what comes back on faults.

Hi Kerstin I can tell you what these parts do and you have to re-open the panel and find out yourself where they fit. these parts are to take the light from the bulb and distribute it inside the panel, so basically the circle in the middle of the part goes on top of the panel bulb. from here you can find your way. Good luck

-Dirty and too much sand on the rail. Clean it and lubricate. Good Luck Mai

This question was already answered by dannydoesita. GOOD LUCK FRIEND.

Whether you have a 4cylinder or a 6 cylinder look towards the transmission. The starter will be on the engine towards the transmission at 3 o'clock front of car or 9 o'clock between engine and fire wall.

Replace cable. Probably going to be a lot of rust damage.

yes grind back fibreglass the fill ,smooth down repair and prime and paint

Lift the door handle as if you were opening it Hold the handle & use a round phillips to hook & rotate the white door latch to the open position

double posted, back up one

blown fuse. check all fuses, both boxes the wiring is at, alldata.com if get lost, its all there. use any voltmeter to find reason. if not a fuse. ask

this is called the axillary heating system option (got that?) and is a totally different system from front, (standalone) they run hot water to the rear of car. an amazing feat. via the A-pillar left. (usa LHD) first check all fuses. (the endless statement) it's a bad damper, stuck or bad damper motor. we call this HVAC, distribution failure. all cars have dampers. only how they move , varies by maker or year. most honda use damper motors. (yours does) you push a button (rear ) and the damper moves and bingo heat to rear. THE FSM covers this is vivid details. and tests. get one at helm or off fleabay used. or try alldata.com my online source is weak on this subsystem. the FSM covers it. it does have 2 blend motors. id make sure both work right if not, fix that. (the fsm covers these tests,) showing how to apply power to the conn. and test it. the front and rear work simular but are 2 systems.

The AC compressor relay may be stuck on and defective. Find the AC relay and swap it with another relay-others in your car may be same relay-same part number on it, and same number of relay terminals. If another relay or new relay doesn't help, the wiring will have to be checked. The relay is usually turned on by the engine computer sending a signal to the relay.

need to get a slim jim so you can unlock it and get in your car

The fuse box for the sliding back doors and the tailgate are in the 'secondary fuse box' under the hood:#2 40 amp fuse - Left Power Sliding Door#3 40 amp fuse - Right Power Sliding Door#4 40 amp fuse - Power TailgateDon't know if you were referring to the doors or tail gate but if you were talking about the doors and trying to use the button to open them, make sure the MAIN switch is in the ON position or you will have to open manually. Any info, including fuse locations, are located in your owner's manualHope I was able to help you, please rate my post if this works out for you.ScottASE Certified Automotive TechnicianASE Certified MED/HVY Truck Technician

You should go see a body shop. Without further information on the problem it is impossible to diagnose, but unless you have experience with cars, I would stay away from trying to do body work on your own - it is unsafe and will not turn out well. -Alex

Give me some more information about this problem. May be i can help.

Sorry mate, there are only a few places that this would be. You can check your owners manual ( as the original salesman may have written it down some where in there) or the dealership. These are a security code for an out dated anti-theft control. There is no way to decipher this or generate it.

Check to see that the button on the player that says "Rear Power is in the correct position.