20 Most Recent
2008 Ford Taurus X Questions & Answers
How to repair a drivers heated seat on a 2007 Ford 500
The following checks and repairs can help you:
1. In the fuse box within the bonnet - check fuse number 22, if burnt, replace it
2. Check fuse 19 in the fuse box inside the car located under the dashboard on the driverside
3. If these steps don't help, the problem may be with the wiring and connection between the module and the seat cushion - inspect it
4. Check if the signal return on the circuit is adequately functioning - if the module is being informed of an active seat
5. If there is a problem - repair or replace the circuit and/or wiring.
Taurusx 2008 air conditioner blowing hot air as of
Sounds like your AC clutch has fragged, Take it to a technician as these can be a real PITA to get to and work on. You will likely end up replacing the entire AC compressor as most techs won't just do the clutch and guarantee their work.
2008 Ford Taurus X. Drivers side heated seat
Hi, its bad news im afraid it is the heating element its over heated which they do from time to time so the only way your going to solve this is replacing the element, if the light wasnt lighting up at all then it could have been a fuse or a wire worked loose but as the light is flashing this is showing you a warning message that the unit is no longer operating due to a problem with the heating element.
the only option you have of solving this is to get the whole heating element replaced and the rest checking to ensure it wasnt a short that caused the element to pack up
let me know if you need further assistance ok
im sorry i couldnt give you good news or an easy fix but if you had said the light dont light up at all then i would have said check fuse and or the wiring harness but as your are getting the flashing light then this is telling you that the heater is cutting off due to a fault with the element.
Change oil still showing after oil and filter is changed
In Ford Taurus X, after an oil change, the oil life indicator can be reset to 100% by holding the reset (system check) button. It will prompt you whether you want to reset to 100%. Set it and it will come back to 100%. This step takes hardly 10 seconds.
Not finding what you are looking for?