20 Most Recent 2009 Dodge Journey - Page 6 Questions & Answers

Best suggestion is to go to parts house and find a Chilton/Haynes manual for your vehicle. From the diagrams shown online it a bit of a bear to access and may be best left to Dodge dealer. Also, according to online articles, there have been some known issues regarding this vehicles starter system and some recalls.

I had a similar noise. It turned out to be one of the motor mounts (broken).

Alarm

how do you change heater hose on 2009 dodge journey 2.7 v 6

The fuel light comes on when there is approximately 1/8th of a tank remaining. If you are always running low on fuel, the lamp will remain on constantly.

remove and test speakers elsewhere, test with other speakers, follow cable to stereo check for kinks. some workers will swap out for their own faulty ones hard to prove though.

First, you need to disconnect the negative battery cable. Then loosen up the front fascia on the side where you are removing the headlight assembly. Remove the 4 push pins that fasten the upper grille to the FEM (Front End Module). You will then need to push the fascia and grille forward enough so that you can remove the three screws which hold the headlamp assy. to the FEM. Finally, you pull the assy. far enough away from the FEM to reach the headlampand dash wire connectors from the rear of the headlamp housing.

i would check the fuses for the passenger and passenger side front windows. It doesn't sound like a motor issue as both sides aren't responding. since both sides are not working it most likely isn't the switches. it might be the regulator, however, it's suspect that both side are failing at the same time seems to be a fuse issue. I would look at this first and then work my way through the system. good luck

the Dodge Journey does not have a serviceable fuel filter

REAR OF ENGINE COMPARTMENT BELOW WIPER COWL , CLOSE TO THE EVAPORATOR INLET

Check your universal or CV joint... Must be loose. If they are ok, your transmission may need to be serviced.

You will need to go to the dealer for a software update,the RA4 has a recent update that may address this issue and the dealer may be the only way to get it.Go to the system info on the radio and see if the software version is at least 14.0. if it's 13.48???? it needs the update

The line is on the firewall in the engine compartment

remove the front wheel and support the van then remove the two bolts that hold the caliper then remove the old pads then using a clamp or big channel lock plies press the caliper piston in so the caliper can go on after you put on the new pads after you would of replace your wheels pump up your breaks and check to see if you need to put in some more brake fluid

remove the wheel after supporting the car,with a jack stand, then you remove the two bolts that holds the brake caliper then remove the old pads then you push back the caliper piston with a clamp or a big channel lock pliers replace the new pads and after you did the two front wheels start your car and before moving pump up the brakes properly