20 Most Recent 2009 Dodge Challenger Questions & Answers

This may be as simple as relearning the window stop positions. Perform the following procedure to relearn the windows; 1) Sit in the drivers seat and ensure both doors are fully closed. 2) Turn the key to the ON position but do not start the vehicle. 3) Pull up on the drivers window switch until the window reaches the full up position, then CONTINUE HOLDING THE SWITCH UP for 2-5 seconds, then release the switch. 4) Push down on the drivers window switch until the window fully opens, then CONTINUE HOLDING THE SWITCH DOWN for 2-5 seconds, then release the switch. 5) Repeat steps 1-4 for the passenger window. 6) Close both windows and check the operation of the smart glass. Let me know if you need further help. Nate I’m happy to assist further over the phone at https://www.6ya.com/expert/nathan_cc888cf971f43e78

Sounds like you have blown a fuse. This fuse is usually one of the fuses under the hood, in the black fuse block. It will likely be one of the fuses that is in the YELLOW carrier. Test the fuse and replace with the same size fuse. By testing, I mean that you should use a test light and touch the top exposed metal parts of the fuse. If the test light is hooked up to ground (metal of the car) the test light should light up on both sides of the fuse. If there is only power on one terminal of a fuse, that is telling you that you have a blown fuse.

I do not know about your vehicle but it sounds like a possible lack of lubrication in its gearbox or bearing wear. As things warm up metals expand to free themselves, or low lubricant may take its time to "splosh" up to higher positioned shafts and gears in its box after draining down overnight. I would check this out urgently as friction can make things weld together (look up friction welding) which should not thus destroying a gearbox. Hope this helps........

If you have the HID system it sounds like the control module the bulb mounts into

year, make, and model with engine size please? Master Tech Lee Auto Repair Help US

if it does it will say DOHC on top of the engine

when the check engine light is on it means that one or more of over 200 poss faults has occured in the electronic engine or emission controls systems, to find out what the fault code is for the problem u will need to run a fault code test of the OBD 2 electronic control system, most Discount auto parts stores lioke Kragen do this for free.

Check your owners manual fo rthis information, it is in there with pictures. If you do not have the owners manual you can access one for free HERE.

sounds like the motor has gone or electrics