20 Most Recent
2009 Buick LaCrosse Questions & Answers
How is the bulb replaced in the low beam headlamp
Not sure how easy it is on your car, but the lamp is accessed from behind the headlight assembly, under the hood. A ring or some kind of retainer may hold the bulb in place. When that is removed or released, the bulb should come out with its connector plug attached. Replace bulb and put it back together. Good luck.
2009 buick lacrosse console gear indicator bulb
Transmission Floor Shift Control Indicator Lamp Replacement
Remove the front floor console. Refer to Front Floor Console Replacement.
Rotate the floor shift control indicator lamp socket (2). Pull the socket from the trim bezel.
Remove the bulb from the socket.
Front Floor Console Replacement
Preliminary Procedures
Remove the rear floor console. Refer to Rear Floor Console Replacement.
Remove the instrument panel lower trim plate. Refer to Instrument Panel Lower Trim Plate Replacement.
Set the parking brake, then shift the transmission into drive and push the shift indicator down until it locks, to allow clearance to remove the console.
1
Front Floor Console Screw (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2 N·m (18 lb in)
2
Front Floor Console Bolt (Qty: 2)
Tighten
10 N·m (88 lb in)
3
Front Floor Console Assembly
4
Front Floor Console Retainer Clip (Qty: 2)
Fuel filter on a 2009 Buick Lacrosse where is it located
After a cursory look into its location, it seems that your car does not have a replaceable fuel filter in the usual sense. There is a strainer in the fuel tank attached to the fuel pump inlet but that's it. Like I said, it was a brief search. What I usually do in these situations is try to find the part to get an idea of what it looks like. If its a metal canister, it obviously would go outside of the tank. If all they show is a strainer/screen/sock type of part, it goes in the tank. Hope this helps.
What does the code b0026 mean on my 2009 buick lacrosse?
DTC B0026: Driver Frontal Deployment Loop (Stage 1) Open
It has to do with air bag system
B0026 Stage 1 or B0044 Stage 2
?€¢
The steering wheel module stage 1 or stage 2 high circuit is less than 2.4 volts and the steering wheel module stage 1 or stage 2 deployment loop is more than 6 ohms for 500 milliseconds.
?€¢
The steering wheel module stage 1 or stage 2 deployment loop resistance is greater than 4.8 ohms for 500 milliseconds.
has to do with
What agency handles GM dealership fraud?
I would probably start with Buick's website - - you can email or call for customer service. They should be able to take the complaint or direct you to that department.The phone number is 1-800-521-7300. There are other numbers at the GM website too.
Automotive question
If the core is not leaking, you need to have it back-flushed, not replaced. Your girlfriend is being ripped off.
10/13/2012 12:29:32 AM •
2009 Buick...
•
Answered
on Oct 13, 2012
Not finding what you are looking for?