Nissan 350Z - Recent Questions, Troubleshooting & Support

Question edited for clarity. Question moved to model category. Information here on the forum

how do i do the throttle body relearn procedure???

My350z https://my350z.com > ... > Maintenance & Repair Jul 7, 2008 - Try this: Disconnect accelerator pedal position sensor. Wait 30 seconds and then reconnect. Disconnect electric throttle control actuator. Wait ... Re-programming throttle body - MY350Z.COM Apr 13, 2004 Idle relearn is not working! - MY350Z.COM Apr 14, 2017 Official ECU reset procedure - MY350Z.COM Apr 14, 2017 Accelerator Pedal Position Sensor - MY350Z.COM Apr 14, 2017 More results from my350z.com Try this

350z Reset proceedure (Pedal Dance)

Horsham Developments https://h-dev.co.uk > 350z-reset-proceedure-pedal-dance Turn ignition switch OFF and wait at least 10 seconds. Make sure that throttle valve moves during above 10 seconds by confirming the operating sound. Idle Air ...

Replace the bad motor?

very common problem. https://www.justanswer.com/nissan/6f02s-windsheild-wiper-fuild-light-will-not-go-off-everything.html

Its probably the motor for sunroof. Heat from sun is probably tripping the thermal protection breaker in motor. Only way to fix is replace it.

The key switch may be worn enough that it is not turning all the accessories off when you pull it out.

Turn off the traction control.

Does it unlock the other door? Have you checked the battery in the remote? If battery is dead, you may have to reprogram the remote after replacing.

4 different O2 sensors in a 350Z,has it got stock exhaust or modified?

reset using the code reader. The best advice is to use the fault code reader as it will save mega money in future.

Look closely to see if anything was dropped or anything heavy placed on the latch. It may be bent ever so little. If not then your servo is losing its value and will have to be replaced.
I hope my suggestions helps and all the luck to you.
burdfrenzy
http://stores.ebay.com/Pittsburgh-Joes-Pants-Nat

You need to have the codes scanned for the top. Their are many sensors and switches to these. Not to mention the mechanical parts. I suggest you don't use it till you have it diagnosed.

Remove the front seat can give you access to remove the panel. But if it has screws around the outer perimeter, most likely will have to tear it out. Best to find a replacement first. Look at the drivers door, if it has screws, so does the passenger side. There are screws around the arm rest and door handle to remove, then it pops off. Again the seat has to be out of the way.