Mazda MX-3 - Popular Questions, Answers, Tips & Manuals

fuel lines are made of steel not copper

Timing out by a little bit? Not a rotary is it ,cam belt or chain dont know what mx3 has being a tooth off correct position caused by tensioner ?or a sensor crank or cam ,needs pluging in to a reader or if its early ecu may flash led with fault code.hard when cars on other side of world

clutch is not disengaging when pedal is pressed no hydraulic fluid slave cylinder leaking clutch master cylinder failure air in system clutch cable broken take it to a clutch and brake specialist shop not a clutch problem

You have a shorted out wire somewhere. Any damage lately or accessories fitted?

I think someone has misled you. Even if you were able to get it to work by tapping it, you can be sure the problem is going to come back. You need to have that starter tested if you think it is the problem.

Could be a shaft can you smell smoke under the hood if it's the clutch you could smell it burning

You need to check the glass heater grid or continuity, turn it on and check across the grid with a 12 volts test light

Does it stall out because the engine is idling slow? Have you scanned the system for codes?

What is the question here?

You may have drilled thru firewall and cut a wire. Look very closely. Thank you and please leave feedback

Welcome To MX 3 com Your Complete Source On The Mazda MX 3 http://www.mx-3.com/ check above url for assistance ....it is dedicated to your vegicle's model

Bad coil or ignition module? Bad crank or cam sensor?

Why did you replace fuel pump? Did you buy a dealer pump or cheap aftermarket unit? Just because it is new does not mean it is good. Have you run pressure test?

sounds like you have a vacuum leak somewhere is you ck eng light on ,

sounds like air intake prob

if you have spark to the cap but not out of the cap you have 2 problems. the cap and the rotor...

Check the cabling and the relay, if the bulbs are ok.

check if power getting to bulbs, if is then the bulb holders may well be distorted due to heat and are not allowing bulbs to seat properly so renew the bulb holders , if no power to the bulb holders and the fuse is ok then its either a wiring fault , check the earth wire from the light cluster if ok them must be the switch

join a real mazda forum and ask them, many cars you can not. the newer the car, the more true that becomes. did you post a ATV to a car forum? a quadzilla Mazda? please post to ATV forum. for best play.

run the fault codes and check for faulty MAP/MAF/VAF sensors