Land Rover Range Rover - Recent Questions, Troubleshooting & Support

Usually people check everything, change the thermostat and forget to check if the cooling fans work? The other possibility is that the water pump is failing. The simplest thing would be if there is a big air lock in the system and the water isn't circulating properly. No heat coming out of vents is a symptom of that because the heater core is high up in the system behind the dash. Read this Tip I wrote. Raising the front of the vehicle is important to fill the heater core as well as putting heating on MAX. https://www.fixya.com/cars/r29872074-vehicle_cooling_system_no_heat

Why is My Land Rover Overheating? ' Service Tips in ...

Land Rover Anaheim Hills https://www.landroveranaheimhills.com > service > wh... What to Do When a Car Overheats · Turn off the air conditioning and crank the heat up high. This will help remove heat from your engine block. · Pull over and ...

Why Is My Range Rover Overheating?

Range Rover Fanatic https://rangeroverfanatic.com > Troubleshooting Apr 27, 2023 - One of the most common reasons for engine overheating in Range Rovers is a lack of coolant flow through the system. This can be caused by a ...

2006 range rover hse (non supercharged) overheating. Help!

landroversonly.com https://www.landroversonly.com > threads > 2006-ran... Oct 26, 2019 - If the system starts to overheat after a few minutes and nothing seems to bring the temperatures back down you may have a headgasket issue or a stuck thermostat ... 2006 AJ Engine overheating 4.4 HSE Jan 29, 2019 2006 land rover lr3 se v8 4.4l air in the coolant system help ... Feb 5, 2020 2013 Range Rover Sport 5.0 Overheating May 11, 2022 2008 LR2 overheating and A/C problems??? Apr 24, 2012 More results from www.landroversonly.com .. Not sure how the transmission video got in there but I can't remove it!

no year car told and worst no engine told and is an engine question. 1994 to 2001 made. 3 engines 1 is diesel,2.5 BMW any car that will not start ! the driver cranks the battery dead. so sure it can NOT start THE ENGINE now. the shop manual says in this case keep the battery charged to diagnose all fail failures, EFI,engines or all electrics resetting the BCM does not fix this. yes pulling battery neg lug for 15min and back on resets computers. there are 6 to 10 causes of a dead starter motor, and battery dead or loose rusty lugs tops the list, ever jumper cable , jump start a battery? call the AAA AUTO CLUB AND SAY JUMP ME rovor? NOW IF THE BATTERY WAS CHARGED AND WE CRANK IN PARK WE FAIL WE CRANK ALL CARS IN NEUTRAL , SEE IT DOES CRANK? HEAR THIS , THIS CRANKS BUT WILL NOT START https://freesound.org/people/drdeath666/sounds/687447/ WE CAN NOT HEAR YOU CRANK YOUR CAR, DEAF AND BLIND IN THIS TEXT BOX.(ME) IF IT DOES CRANK FAST, THAT IS A NO START ONLY ! WE SAY CRANKS FAST BUT WILL NOT START. (BATTERY GOOD) AND HAS UP TO 50 CAUSES AND 20 TESTS AND TOOLS TO FIND IT. (CHECK ALL FUSES. AND SCAN THE OBD2 SCAN PORT IS FIRST. THE CAR NEEDS SERVICE FOR SURE. the only tool less tests are fuses and cranking in neutral. just 1 eye and 1 hand does it. ok one more engine oil all leaked out. engine seized.grin! dip stick dry, via Mark one eyeball check/.

Question edited for clarity. We are in North America and no one here knows what 'P38' means except me as I am British :>D We are better with full 'year make model'. Question moved to correct Category. Immobilizer issue as mentioned in the Range rover Forums https://www.google.com/search?q=Range+Rover+148+interface+immobiliser ..

turn ignition switch on position for 20 seconds then try to lock and unlock doors.if you have sun roof open sun roof fully then close sun roof fully. then switch off ignition switch then try to start.

hi, this is due to a couple of things. 1 is this a p36 or p38.
things like the door sensors will prevent this from lifting, its to stop it crushing your leg when foot is out.
more than likely there are 2 hieght correctors.
depends on the model. i see these where leg pops out, i get them in where a air bag has popped off, loosing all your air.
when its a p38 and lifted, if u dont push the button on the dash the computer gets confused and wont let it lift, this then needs a reset. i have lifted a lot of range rovers and the p38 is the worst, i use a 2 post lift, u got to push button on dash, this tells it its getting jacked up or lifted. i have forgot to push it a couple of times, a air bag drops off, u need tough thumbs to push it on.
listen to see if the compressor is running when running.
you must open bonnet start engine then shut door making sure all doors are shut, there is a box think it says eas (black box) you can take the cover to see it pumping, u will hear it.
if not you and none of this whats mentioned is at fault u have to have it 1 plugged in or 2 reset. hope this helps u. 1 more suggestion, im not sure about a p36, is the button on the dash on, orange light on, this locks the suspension for lifting, when down wont go up.
get back to me how u got on, i will have another think. im sure the sensor on axle.

open glove box pull guide (users) see fuse page for relay names. try cranking in N PRNDL ,no just P ? that is first but if starter is silent the relay is not. so if relay too is silent it is bad park/neutral switch is dead. scan the PCM with a scan tool,OBD2. see why it fails easy. park lock out must work first. battery charged. key on, step on brake pedal shift from pARK tro neutral and crank the engine. if Park switch was bad, Neutral is not.(joy)

1 Check for the "Remote Battery Low" signal message that is displayed on the vehicle's dash once the remote key battery starts to run down. Be sure to replace the battery is before it dies completely. If the battery is dead, it will not be able to start the Range Rover. 2 Buy the correct battery for replacement. Two round CR 2025 batteries are needed. You can purchase them at most major supercenters, camera stores or **** stores. They are a common size and should be readily available. 3 Use a nickel to remove the battery holder on the key remote. Turn the cover until the arrows line up and remove it. The cover fits very tightly and you may need a small screwdriver to pry it off. Remove the battery holder and circular ring from the remote. Take the old batteries out of the battery holder. 4 Place the new batteries in the battery holder. Replace the battery holder and circular ring in the key remote, aligning the arrows. Turn the cover clockwise until it is secure. 5 Resynchronize the key by simply placing the key in the door lock. Lock and unlock the door to the Range Rover and then press the remote control.

The Dynamic Stability Control uses your brakes. You need brake repairs.

Sounds like your anti-theft is locked, if you do not know the code you can check with the dealer all he needs is the vin

Turn off the ignition with them at the rest position. It should reverse it and trick the module controlling them.

The easy way need to be done:-Make sure the is not presure in the cooling system before do thisor release carefully.-Disconnect the upper hose from the radiator and fill water (coolant)through the hose to the engine. If water can't get in beacuse the thermostat is closed. Simply remove it and fill untill full.Mai Lor

Some models of Range Rover have a hidden key slot to manually open the drivers side door. Try this. Take a close look at the door handle at the section that does not move. On some models this is a small cover that is held in place with adhesive tape. GENTLY lever the cover off but DO NOT force it off as this could damage the handle cover. I would suggest use a piece of rag over the grip section of handle and lever at the joint position to avoid scratching any paintwork. Once the cover is off turn your ignition key in the slot to unlock the door.

A stuck thermostat is the likely cause of that. If you remove the radiator cap and start the engine you should see water movement.

i would try asking your local auto parts store

Have the vehicle scanned for trouble code and go from there since it can be a number of reasons for your problem

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything someone on fixya recommended it to me and I thank him even today They have full manuals and it's verrrrry cheap and mine I got free in offers 3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins there is one website more but i don't remember its name it was 2 years back bitman something link this Try these out brother

Remove the inside trim and undo the mounting screws. Suggest you do not try to adjust the internal parts of the mirror because it is inevitable to mirror will not want to go back into its designed position. Better to find a replacement unit

have your wheel bearings checked and service your tie rod ends and ball joints.

turn on your bluetooth on your samsung while truck is on. it will scan for your range rover. phone will ask for code type in 2121. i have a samsung note 3 and thats the code i use. im assuming it"ll work on any samsung phone.

sorry but you have tried everything i would have done except that i would have checked the engine breather pipes for deterioation like perished or soft and collapsing .you would be surprised how often this is the main cause of this sort of problem