Kia Sorento - Answered Questions & Fixed Issues
2006 Kia Sorento. It cranks but doesn't start?
Sorento cranks but wont start - Kia Forum
kia-forums.com
https://www.kia-forums.com > threads > sorento-crank...
May 8, 2016 - You can try resetting the fuel cutoff switch. It is located near the windshield, passenger side behind the reservoir under a small black rubber ...
Engine turns over but won't start, HELP - Kia Forum
Apr 15, 2009
Help, Kia cranks but won't start!
Mar 6, 2008
Cranks but won't start? - Kia Forum
Sep 3, 2012
Sorento runs then won't start for several hours - Kia Forum
Aug 30, 2011
More results from www.kia-forums.com
My Engine Cranks but Won't Start (6 Reasons Why)
AxleAddict
https://axleaddict.com > auto-repair > My-Engine-Cra...
Mar 28, 2023 - Answer: If the engine cranks but won't start, it is turning over. Start by checking that you got good spark and fuel pressure. If the problem ...
I have a 2006 Kia Sorento LX 3.5 l engine I replaced the
JustAnswer
https://www.justanswer.com > Kia Troubleshooting
Apr 18, 2022 · 1 answer
If the fuel pump and starter do not have any power, you need to start by checking the fuses and checking for codes in the computer using a ...
2014 Kia Sorento LX is running a bit rough, exhaust is smelly and error codes
THE CAR NEEDS SERVICE, GET SOME?
no country of VIN told , no engine told. guess at V6 I will, 3.3L
that o2 heater is dead. or the 4wires to the oxy sensor are burned up on the exh. pipe. toss coin or better just look at it.
sensor #2 is behind the CAT. and is bad.
you posted no engine told at all, and is a 100% engine question.
S1 is always front of CAT, S2 is rear.
upstream or down stream, (S1 /S2 order)
B1 bank 1 means that bank that has cylinder #1 there.
on the 4 banger #1 is front of engine a belt drive end.
on a V6 , the #1 cylinder is most front (it's off set to bank2)
3.3L back bank row is B1. (drivers end)
so bank1 s2 is that exhaust manifold rear that goes to cat #1 and the rear of cat 1 is B1, sensor S2 rear of cat.
the heater circuit side never lies,it means the voltage or current flow to that heater is dead wrong. open/ or shorted heater or its wires to it.
the gen 3 car? 2014
engine line up is here.
Petrol:
2.0 L Theta II T-GDi I4
2.4 L Theta II MPi I4
2.4 L Theta II GDi I4
3.3 L Lambda II MPi V6
3.3 L Lambda II GDi V6
3.5 L Lambda II MPi V6
Diesel:
2.0 L R II CRDi I4
2.2 L R II CRDi I4
keep in mind my answers are USA only
and USA EPA. DICTATES CAT LAY OUT AND DESIGNS.
SOME CARS RUN Y PIPE TO A SINGLE CAT. V6
WHAT YOU HAVE THERE , IVE NOT 1 CLUE.
Not finding what you are looking for?