Jeep Cars & Trucks - Page 4 - Recent Questions, Troubleshooting & Support

To confirm the exact fault,the error code stored in engine computer module has to be retrieved.
But as why check engine light came up,for that issue there are few help link with solutions to correct the issue.========
Click the link below:---
After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?
------------How to Read Codes from Check Engine Light?
------------Check Engine Light Reset Procedure?
------------- Check Engine Light ON?
----------- Intermittent Check Engine Light?
---------- Service engine soon Light Turned OFF after Jump Start?
---------- 2005 Chevy Impala: Service Vehicle Soon Warning Light?
--------- Malfunction Indicator Light ON
--------- Car jerks while going uphill and Check engine light is ON?


Toyota Camry Check engine light flashes while driving?
----------1999 Toyota Tacoma: Check Engine Light Read Code P0171?
2007 Toyota Highlander Hybrid: Yellow Check Engine Light ON dash?

--------Check engine light with codes P2195 and P2197?
---------Car Runs Fine But Check Engine light is ON?
----------After replacing throttle body the Check engine light starts blinking?
---------OBD Code is cleared but check engine light will not RESET?
--------These will help.Thanks.

2002 Jeep Grand... | Answered on Dec 11, 2019

pull the neg battery cable for 10 mins

Jeep Cars &... | Answered on Dec 11, 2019

Have a jeep patriot had a few issues with engine light coming on, took and had new sensor fitted stayed off a few days. Car shudders and jolts at low revs when accelerating sometimes and my mpg was at 25 around the town but now 18 maximum, need some help regarding wether it's worth taking back to have the light cleared to come back again! Worth a car battery reset? Also have a dodge petrol cap, takes ages to fill up stops every 50p of fuel, could this be the engine light problem or is their a separate light for that, any advice would mean the world regards

2007 Jeep... | Answered on Dec 10, 2019

90% chance you have bad solder joints in the pcm...very common on these... try wiggling the 3 pcm connectors while trying to start. if it starts you need a pcm repaired or replacement..when it happened to me i got a junkyard one... no chipped key on mine

Jeep Cars &... | Answered on Dec 08, 2019

If your engine still runs when you removes the spark plug wires... you have other problems... PLEASE take this to a professional and DO NOT run it unless mandatory.

Jeep Cars &... | Answered on Dec 08, 2019

When you activate the front washers. Do the wipers also activate? If not check for a blown fuse first. This vehicle has one pump for the front wipers and one for the rear. You will need a test light or multimeter to continue and you will need someone to assist you during testing. If the front wipers are working then you need to test the wiring to the front pump. Locate the front pump and unplug the electrical connector. You will use your tool to test for 12V grong to one terminal and test for 12V momentary power at the other terminal. Your helper will be needed to test for the momentary 12V power. You will ask that person to turn the ignition key to the RUN position (NOT RUNNING) and activate the washer pump level. Through one of your tools you should see power when you ask them to activate the washers and you should see the power go out when you ask them to release the lever. If no power is detected. Verify that your tool has a good connection on both connection ends. If there is power and ground you most likely need a new pump. If there is no power you will need to let me know how you want to continue.

Jeep Cars &... | Answered on Dec 06, 2019

If your radio is getting power then your fuse is not burnt out. Your radio probably is the problem for not having any sound. the sound is a function of the internals of the radio. your best bet is to either go to the wrecking yard and purchase another radio that fits your Jeep compass. Install it and see the result. My gut feeling is that your current radio just went south and its time to replace it.

Jeep Cars &... | Answered on Dec 06, 2019

There is no fuse just for the front power windows . A main power supply fuse for the driver an passenger door modules supply's power for door locks an all power windows . Locks an windows are controlled by the door modules (computers) . The driver door module communicates with the passenger door module via C.A.N. - controller area network serial data bus . Watch this video , it's not the same make , model or year ,but jeep is a chrysler product , an yours works the same . Watch this video , pay for a repair manual supplier like

An buy yourself a professional scan tool like the guy in the video an check for DTC'S - diagnostic trouble codes .

Jeep Cars &... | Answered on Dec 02, 2019

You should find a switch on the top of the steering column.

Jeep Cars &... | Answered on Dec 01, 2019

How fast ? 80,100, 140 mph ?

Jeep Cars &... | Answered on Dec 01, 2019

Which window switch ? driver master switch ? Check for broken wire inside the rubber boot from the body to the drivers door . What year , model jeep ?

Jeep Cars &... | Answered on Nov 30, 2019

2004? Check the coolant, water pump, thermostat, plug up the radiator.

Jeep Cars &... | Answered on Nov 30, 2019

the stalling out could be a number of things like a vacuum leak or gummed up spark plugs. also make certain the distributor wires are not arcing to the motor some other place other than the actual plugs. what is the psi on the fuel line AFTER the pump? is there a inline fuel filter that might be clogged up?

Jeep Cars &... | Answered on Nov 29, 2019

I would first make sure there is gas. If the tank is on empty or close to, add two to five gallons. Next you need to verify that the spark plugs are getting spark and fuel. Let me know what you found and how you want to proceed. Good luck.

Jeep Cars &... | Answered on Nov 28, 2019

Don't have both Key's or remotes tougher, keep one key/remote away from each other sometimes that's the problem.

Jeep Cars &... | Answered on Nov 28, 2019

No one can guess for you

You have to check for OBD Codes &
use factory trouble charts, to diagnose
that module & find a problem

1999 Jeep Grand... | Answered on Nov 27, 2019

Not finding what you are looking for?
Jeep Logo

67,585 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts


Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides