Jaguar Cars & Trucks - Page 6 - Answered Questions & Fixed Issues

Check for power at the bulb socket. Check where the light grounds to the body.

You don't. You replace the AC condenser with a Bypass Pulley. It uses the same belt and routing and fits in its place. https://www.google.com/search?q=03+jaguar+x+type+3.0+ac+bypass+pulley ..

See if the videos and articles help. First one says is needs a calibration tool. https://www.google.com/search?q=2003+Jaguar+XJ6.+How+can+I+equalise+and+reset+air+suspension+and+ride+height+after+fitting+a+new+sensor ..

It is a regulatory safety device. You need to fix the Emergency Brake, not find a way around defeating it. Check out the videos https://www.google.com/search?q=2005+jaguar+s+type+emergency+handbrake+release ..

Question edited for clarity. Check the link. Click on the images tab. https://www.google.com/search?q=07+jaguar+s+type+smog+pump+location ..

YOU CAN PLUG IN A BOOSTER BATTERY INTO CIGARETTE LIGHTER IT WILL GIVE CAR BATTERY POWER TO JUMP START. AND YOU WILL HAVE POWER ALSO TO OPEN TRUNK ALSO TO REMOVE BATTERY.

google radio code for the website.
there is a $20 bcharge which is far cheaper than a Jeep dealership charges you

Yes the leaper can be fitted without drilling. The holes are under the badge, which are fixed on with double sided tape. If you are from the uk these are illegal and you can be stopped

Time to servie the gearbox before a catastrophic failure.

Because they are made by different manufacturers. Ford, BMW, etc.

google 1998 jaguar cooling fan relay location

should list fuse location in your owners manual

The throttle control body won't stop it from starting. You need; a spark, fuel and air along with compression. Which one is missing.

personally leave that stuff to the people that know what they are doing , but not dealers

images in the link https://www.google.com/search?q=2003+Jaguar+XJ8+4-liter+engine+head+bolt+torque&rlz=1C1QJDB_enCA643CA644&sxsrf=AOaemvKwirPqgavevxQLywqFuabJ7LAhQg:1638814240595&source=lnms&tbm=isch&sa=X&ved=2ahUKEwj_86bl4s_0AhUQa80KHbqcC2wQ_AUoAnoECAEQBA&biw=1920&bih=937&dpr=1 ..

this is not a recommended diy project Pay a brake service

6 liters 5W-30 Jaguar exclusively recommends Castrol EDGE Professional oil,

fuel pump relay?

car shakes which is called shimmy shake,if brake pads been replaced wheels still shimmy, you have worn brake rotors with low and high spots,you could have bad wheel bearing, you have worn out tie rod ends and worn out ball joints,you could have tire out of balance,also you could need front end alignment.many things will cause wheels to do the shimmy shake.

Use a crowbar