Hyundai Accent - Recent Questions, Troubleshooting & Support - Page 9

On most vehicles top radiator hose goes to thermostat. God-Bless!

The clutch must be fully depressed before the starter motor can turn.

Another person had a similar issue with their 2003 Hyundai 1.6L engine. Their fix after looking at many things was that their ECM relay had gone bad. The relay is located in a box under the hood. The box has fuses and relays ... usually there is a legion or map of what is where on the underside of the box cap/lid. The relay is about the size of a one inch cube.

P0650 Malfunction Indicator Lamp (MIL) Control Circuit Malfunction

Malfunction Indicator Lamp (MIL) is located on the instrument panel. When the ignition switch is turned ON without engine running, MIL will light up. This is a bulb check. When the engine is started, MIL should go off. If MIL remains on, the on board diagnostic system has detected an engine system malfunction.

Possible Causes:

Harness or connectors (MIL circuit is open or shorted.)

MIL bulb may be faulty

Battery is probably bad, or connections to it are really oxidized. Battery can be tested by any AutoZone or similar store that sells auto parts. Lastly it is possible that the alternator is bad or you have a slipping belt that runs the alternator. This would account for the battery not getting recharged. Try a new battery first.

It is not the relay. Most likely problem is failure of the latch.

It's located right at the bottom of the washer fluid reservoir. Remove the right front wheel well liner. That'll give you access to the bottom of the reservoir and the front washer pump

Sounds like the starter motor is shot.Try tapping the starter while someone is cranking the engine

You don't give us a good description of the sound you 're hearing and where you think it may be coming from.

Take it into a shop before damage occurs to the cats. Is that really the only code? Sounds like it might be a fuel issue but definitely get it looked at asap, cat damage can be a lot more expensive than some quick maintenance

Do you a trouble code?Service engine light on

Maybe the wiper motor linkage is the problem . Try an run the wiper motor by it's self .

Take it to a qualified repair shop . One that has a professional scanner an know's how to use it , an has factory sevice repair information and the knowledge to diagnose . Or go on youtube an search the code's an learn how to test .

go to the given link get the manual and solve the problem http://toolsnyou.com/

take out the cubby with the dimmer switch. and it's right behind that. its the top small black one.