Honda Cars & Trucks - Answered Questions & Fixed Issues


Is this from opening from the inside of vehicle ? if so check for the child lock button isn't engaged, by the lock mechanism on the door

Honda Cars &... | Answered on Jan 15, 2020 | 18 views


What is the problem

Honda Cars &... | Answered on Jan 14, 2020 | 33 views


it sounds like your lock actuator inside the door is bad

2000 Honda... | Answered on Jan 13, 2020 | 648 views


Take help from online websites that have this service like helping in repair some like reliable -store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Honda Cars &... | Answered on Jan 11, 2020 | 13 views


Take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Honda Cars &... | Answered on Jan 11, 2020 | 13 views


Step 1 Remove the center console cover around the parking brake lever located inside the car between the driver's seat and the front passenger seat.
Step 2 Turn the adjuster nut with your wrench or pliers located at the end of the parking brake cable rod, to loosen the adjuster nut. Make sure it doesn't come off the end of the parking brake cable rod.
Step 3 Raise your Honda Accord rear wheels in the air using your jack and support both rear wheels with your jack stands.
Step 4 Pull up on the parking brake handle for two notches or clicks. Tighten the adjuster nut until there is a slight resistance on the rear wheels when they are spun.
Step 5 Release the parking brake lever. Verify the rear wheels do not have resistance and are able to spin freely.
Step 6 Pull up on the parking brake lever three to five notches and verify the rear wheels do not turn at all.
Lower your Honda Accord using the jack and remove the jack stands from the rear wheels.
Items you will need
  • Wrench or pliers
  • Jack and jack stands

2007 Honda... | Answered on Jan 11, 2020 | 231 views


That is not bad compression, you have something else wrong. IS the fuel good? What is the timing?

Honda Cars &... | Answered on Jan 10, 2020 | 22 views


you seem to have a major short. get an auto electrician to have a look at it.

Honda Cars &... | Answered on Jan 08, 2020 | 22 views


Hey there i got a 1996 honda crv and i was wondering how to change the input to english so i cpyld understand how todo the navi or do i need to update it with a complete new navigatin system

Honda Cars &... | Answered on Jan 08, 2020 | 1,124 views


could be the bulb is burnt, or wiring issue on that side.

Honda Cars &... | Answered on Jan 07, 2020 | 20 views


I heard that there was a filter inside the fuel tank, but I also heard that there is no actual fuel filter...supposedly there is a fuel strainer located inside the fuel tank. Usually an inline fuel filter is between the fuel tank and the engine.

Honda Cars &... | Answered on Jan 05, 2020 | 20 views


You say that the rear wheel is stiff? Check to see if something is jammed in the rotors or the wheel is not centered on the hub. Did something get bent when the rear was lifted to change the struts?

2004 Honda CR-V | Answered on Jan 03, 2020 | 112 views


First, please review this article: Where's The Fuse?

Then to answer the question you asked:
There are actually 3 fuses involved in your rear wiper system.
They are all located in the driver's fuse/relay box located under the left side of the dash.
Fuse #7, 7.5 Amp
Fuse #21, 7.5 Amp
Fuse #30, 20 Amp
These same three fuses, if blown, will also have the symptom of the front wipers not working. So if the front wipers are working, the problem has nothing to do with a blown fuse.

There are also several control units involved in making the rear wipers work:
There is the Combination Switch Control unit, the MICU Rear Junction Box Control Unit, and the Relay Control Module. These are also powered (protected) by the fuses listed above.

I would recommend Obtaining a scanner and scanning the Controller Area Network (CAN) in your vehicle to see if there are any fault codes that can help you determine why your rear wipers are not working.

2005 Honda... | Answered on Jan 02, 2020 | 5,945 views


posiblemente mal encendido / interruptor de llave pero necesito m?s informaci?n. Tambi?n estoy usando un traductor ya que solo s? ingl?s

Honda Cars &... | Answered on Dec 30, 2019 | 18 views


Dead battery? Not much to go on here...

Honda Cars &... | Answered on Dec 30, 2019 | 17 views


Check for open fuse and/or defective speed sensor

Honda Cars &... | Answered on Dec 28, 2019 | 18 views


Welcome to FixYa.com
Thank you for using FixYa.com, Regards, Lee Davidian Remove upper radiator hose
Remove the two 8 mm bolts See diagram below bc52022.png

2000 Honda CR-V | Answered on Dec 28, 2019 | 7,921 views


find some online guides..google or there v helpful n u don't need to refer to anythng else.. like reliable- store.com is gud fr this.. do tell me how it goes.. so easy!

Honda Cars &... | Answered on Dec 26, 2019 | 20 views


Check underhood right top side for the fuse box.

Honda Cars &... | Answered on Dec 26, 2019 | 26 views

Not finding what you are looking for?
Honda Logo

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,940 Questions

1991 Honda Accord
1991 Honda Accord

2,649 Questions

1995 Honda Accord
1995 Honda Accord

1,606 Questions

1996 Honda Accord
1996 Honda Accord

1,608 Questions

1998 Honda Accord
1998 Honda Accord

1,531 Questions

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...