GMC Envoy - Recent Questions, Troubleshooting & Support
2008 GMC Envoy. How can I get lighter unstuck?
Drill a hole in a piece of plywood that fits over the lighter. Have someone press the plywood onto the plastic. Put a cord with slip knot over the lighter stem and add a wooden T-Handle to the other end of the cord, you pull and the other person presses.Just noticed this is an old question that has had spam removed which resurrected it...
Incomplete monitors :catalyst 2004 envoy emmisions fail ?
After the MIL is turned off or the battery was disconnected for some time, all monitors are set to incomplete. However with several short trips with engine getting at least to hot enough for thermostat to open, (I believe 8 is the magic number of trips) most monitors are set, you may be able to pass the test with only one incomplete only.
2005 GMC ENVOY 4.2L. I have a P0740 code on it?
DTC P0740 Torque Converter Clutch (TCC) Enable Solenoid Control Circuit
Circuit Description
The torque converter clutch (TCC) solenoid valve is an electrical device that is used with the torque converter clutch pulse width modulation (TCC PWM) solenoid valve in order to control TCC apply and release. The TCC solenoid valve attaches to the transmission case assembly extending into the pump cover. The TCC solenoid valve receives ignition voltage through the ignition 0 voltage circuit. The powertrain control module (PCM) controls the solenoid by providing the ground path on the TCC solenoid valve control circuit. The PCM monitors the throttle position sensor voltage, the vehicle speed, and other inputs in order to determine when to energize the TCC solenoid valve.
When the PCM detects a continuous open, short to ground or short to power in the TCC solenoid valve circuit, then DTC P0740 sets. DTC P0740 is a type B DTC.
Check it out on youtube.
Not finding what you are looking for?