Ford Taurus - Recent Questions, Troubleshooting & Support - Page 5

SEE THE STEPS WITH CAREFULLY AND COMMON SENSE:God bless you Press the unlock button on your vehicle's key fob to deactivate the alarm. If you've misplaced your remote for the car, use the PATS programmed key to unlock the driver's side door. Then, put the key in the ignition and turn the key to the "on" position. The vehicle's battery should be on, but the engine shouldn't be running.

2 Locate the override button on the alarm box, beneath the driver's side of the dashboard. Press the button and hold it in until the alarm beeps one time. The LED light for the alarm should stop blinking, indicating the anti-theft system is disabled.

3 To reset the vehicle's alarm, put the PATS programmed key in the ignition and turn the key to the "on" position. Press the override button. When the alarm resets, it chirps two times and the LED light begins blinking.

the water is draining from the windsheild area there is a drain and that drain has become blocked with dirt or leaves etc

Check wiring

There should be both. Should have a temperature switch, an A/C switch, a defrost switch that all send signals to the ECU. And there is a fuse and relays in the circuit for the low and high speed fan controls.

https://www.youtube.com/watch?v=vAoMQGRZwME

My radiator is located on the passenger side just behind the headlight. It's a plastic container

Most likely is the ecu. the question is it an ECU fault or one of its sensors have it diagnosed at a dealer

It is a Vacuum Distribution Block. Explained in the link with pictures. https://www.google.com/search?q=2006+ford+Taurus+directly+on+firewall+driver%27s+side+top+right+%2Csmall+black+box ..

GOOGLE IT

How many miles are on the transmission? If it's over 100k, it could be the 1st-to-2nd shift solenoid in the transmission. My 01 Ranger started to do the same thing, and that's what the issue was.

Why would you replace an ABS Module
on a vehicle, only 5 years old?

The module !!
The Controller !!

read owners manual -inside cover should have printed what go where --no manual down load [usually free] from online

Is the security light on the dash turned on ? If so, there is a security error causing the problem.Fix the security problem and the other problem goes away.

Most vin are located drivers side window at the bottom of the glass. You can also see it on the drivers door or door post

Check light bulbs. Check headlamp fuses. Check 12V supply to bulb connector. Check ground supply to connector. Check headlight relays should click when light switch ON.

2010 Ford SH0 3.5 l shutters and shakes at at between 20 and 30 miles per hour on acceleration. New call packs new spark plugs all new injectors check Engine light on says catalystic failure.???? Any help

If you are saying a tail light does not work, and you have changed the bulb, have you checked for voltage and ground at the socket ?Could be a faulty socket or wiring problem.

No -

its probably a clogged heater core. not the common jeep blend door problem. backflush it and if thst dont fix it, the blends on taurus are driven by engine vacuum check the vacuum lines

Ignition relay .... There are 2 types of ignition. (1) the ignition key (2) the ignition system that delievers spark to the spark plugs. Why do you need ther relay ?? Does the car not crank over ?? Or does the car crank over and don't start ?? I can help .... but I need more info. please.