Dodge Ram 1500 - Answered Questions & Fixed Issues - Page 7

Ok if you think it is missing from 2 cylinders do a spark test to see where the misfire is then when you would of done that and if you do have spark at all the cylinders do a compression test on the ones that you don't hear a change in the running of the engine,and also if your check engine light is on her it scan to pin point the problem I hope this helps you

You could try going to a specialist that isn't the dealer. The specialist may have a more detailed knowledge of the transmission you have fitted.

This may help. Find it right here on fixya.Com. write for by manufacturer chart. Hope it helps

The OD fuse may have opened or it could be speed sensor failure. The OD off state also could be an indication of transmission trouble.

Have you tried cranking it in neutral ?

The neutral safety effects a no power state at he starter motor.

So if it is not in neutral, you will have a no crank when key is turned to the start position.

Not sure I've ever heard of wiper system using relays. Normally just fuse and motor.

A common problem is the engine being fuel starved due to a failing fuel pump, regulator or plugged fuel filter - cannot keep up with engine demand..

The 2012 5.7 Hemi firing order is: • Coil...1-8-4-3-6-5-7-2 • Plug..6-5-7-2-1-8-4-3

I took my 2004 Dodge Ram 1500 5.7L Hemi to a mechanic that works from a garage at his home, recommended by a friend of mine. He removed and cleaned the throttle body and sensor(s?), then reinstalled them, and then disconnected both battery cables and held them together for 2 minutes so that the engine controller could reboot with the factory default settings, then reconnected them. I had bought a can of throttle body cleaner on my way over to his house for about $3.00. He charged me $40.00 for the job. This was done mid-February, about 10 weeks and 2500 miles ago. So far, the problem Has Not happened again, the truck has been running great!

Here is the link to view the serpentine belt diagram for 4.7 Dodge Ram 1500: https://serpentinebelthq.com/2004-dodge-ram-1500-slt-4-7l-serpentine-belt-diagram/

A diagram should already be available inside the hood on the radiator support of the fan covering. If not, follow this link: https://skippingtheinbetween.blogspot.com/2017/03/30-2006-dodge-ram-1500-serpentine-belt.html. Basically, if the pulleys are grooved, the belt ribs ride on it, and if the pulley is smooth, the backside rides on it.

A 2005 ram 1500 5.7 hemi
Why the engine turns off when the neg. Cable is detached from the batterie?
I already change alternator for a new one.

Hi Javier, Im AL the owner of Big As Auto Repair Javier, ABS Module is located under the hood. It mounts to the side of the hydraulic brake system. Hope this helps and please visit my auto-repair website and check out the satisfied customers and give me a shout while your there. http://www.bigasautorepair.com/

code p0443=It's whining about the control circuit for the purge valve. Make sure you are getting power to the valve, and you see 12 volts on the control side as well. code p0445 might be just a gas cap problem.

What code ?

I think you should try this website big-manuals . It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page

My personal suggestion would be to go for these repair catalogs. I know this website www.reliable-store.com that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.

have it checked for vacuum leaks

Since the tires are a different size than the computer is programmed for that could be the problem right there. U cant fool the computer.