Dodge Ram 1500 - Recent Questions, Troubleshooting & Support


It's a map/tps sensor correlation code, essentially it means the map sensor reading isn't what's expected with the tps reading and vice versa! It sounds like your tps sensor is probably bad or the circuit to one of those 2 sensors.

Hope helps (remember rated this).

2004 Dodge Ram... | Answered on Jan 08, 2020


I think you should try this website big-manuals . It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page

Dodge Ram 1500... | Answered on Dec 16, 2019


My personal suggestion
would be to go for these repair catalogs. I know this website www.reliable-store.com that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.

2001 Dodge Ram... | Answered on Dec 03, 2019


have it checked for vacuum leaks

Dodge Ram 1500... | Answered on Dec 03, 2019


Since the tires are a different size than the computer is programmed for that could be the problem right there. U cant fool the computer.

2004 Dodge Ram... | Answered on Nov 23, 2019


Causes A P0501 DTC trouble code may be caused by one or more of the following:
  • The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
  • There is a broken/frayed wire leading to the vehicle speed sensor
  • The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
Possible Solutions The simplest thing to do is to reset the code and see if it comes back.
Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly.
If the wiring and connectors are OK, then check the voltage at the speed sensor. Again, the exact procedure wil depend on your make and model of vehicle.
If everything looks OK, replace the sensor.
Further Reading Vehicle Speed Sensor (VSS) Description and Operati

2004 Dodge Ram... | Answered on Nov 21, 2019


check with code scanner for fault code/or bring to garage to scan for fault code

2001 Dodge Ram... | Answered on Nov 19, 2019


Watch the video. Ignition Pick Up Coil Sensor Replacement How to Dodge Dakota


This Video applies to all models that use the 5.2L V8

Dodge Ram 1500... | Answered on Nov 08, 2019


Get an OBD reader and see what it says.

Dodge Ram 1500... | Answered on Nov 06, 2019


Fualty blend door or a bad blend door
actuator when when you turn it to the cold side will it cut the heat from the side the is working

Dodge Ram 1500... | Answered on Oct 31, 2019


Press "NAV" to go to the main navigation menu.

Scroll down and select "System Settings"

Scroll down and select "Clock Setting"

Make sure "Show GPS Clock" is selected with a red check in the box.

I had to switch "Daylight Savings" from "ON" to "OFF" in order to bring the time back an hour. I assume that I'll just have to switch it back to "ON" in the Spring in order to move the time forward and hour.

2006 Dodge Ram... | Answered on Oct 17, 2019


"No Bus" means the communication bus is down (the network connecting electrical parts and computers). This is usually a wiring/connector problem. Check for loose connectors, wiring, etc.

2000 Dodge Ram... | Answered on Oct 04, 2019


Most likely problem are the horn pads in the steering wheel. Check to see how sensitive they are when the horn is not engaged. It it honks with very little pressure, then you found the problem.

Dodge Ram 1500... | Answered on Oct 03, 2019


Check engine light comes on constantly nothing seems wrong or Check engine light keeps coming on and something is draining the battery..Which is it ?

1998 Dodge Ram... | Answered on Sep 20, 2019


Take a large socket and breaker bar or ratchet and on the crank bolt at the harmonic balancer and try to move the crank clockwise. This will tell if its frozen up. Also dirty or loose connections at the batt starter and ground can cause this.

Mike.

Dodge Ram 1500... | Answered on Aug 25, 2019


Misfire codes a lot of times will be your individual coil packs. Not sure how many miles you have on your truck, but around 70 to 80 thousand miles you may start getting codes of misfires because your coils are starting to break down. Could also be a combination of coil and spark plugs. If it were my truck and it has high mileage, I would replace all the coil packs, and the spark plugs, and while I had it apart would clean the throttle body which is fairly easy to do.

Dodge Ram 1500... | Answered on Aug 12, 2019


Yes, there is a rev limiter and probably set at 4000 rpm when in park or neutral.

Dodge Ram 1500... | Answered on Jul 24, 2019


It will work fine. The CCA is a rating of how much power that the battery is capable of delivering at once and as the name suggests, cold cranking amps, is needed more in cold temperatures. As long as you are not in the arctic, it should be fine for a couple of days.

Dodge Ram 1500... | Answered on Jul 19, 2019


The ASD relay is controlled by the PCM (computer). The PCM will shut the ASD relay off if it doesn't see a signal from the crankshaft position sensor. Check that sensor and the wiring from the sensor to the PCM.

2000 Dodge Ram... | Answered on Jul 16, 2019

Not finding what you are looking for?
Cars & Trucks Logo

-5,613 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dodge Cars & Trucks

  • Forum

View Most Popular

  • Dodge Cars & Trucks
Loading...