Chrysler Town & Country - Popular Questions, Answers, Tips & Manuals


OPEN HOOD THEN WITH YOUR HEAD UNDER HOOD HAVE SOMEONE TRY THE HORN FOR YOU . .

2003 Chrysler... | 355 views | 1 helpful votes


Remove the radio and disassemble it enough to get access to the stuck CD. Remove the CD and reassemble and reinstall the radio.

Chrysler Town &... | 20 views | 1 helpful votes


How long since batteries replaced in key

2002 Chrysler... | 28 views | 0 helpful votes


Most repair manuals like Chilton's or Haynes have wire diagrams included. You can buy them used online or new from the auto parts stores.

Chrysler Town &... | 36 views | 0 helpful votes


look under dash in fuse box and you will or should see a relay with little slots to emit the sound ,pull it out .

Chrysler Town &... | 71 views | 0 helpful votes


You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single t hing is covered
within seconds u can get the access and it's totally illustrative complete

Chrysler Town &... | 44 views | 0 helpful votes


Most of this vehicles have the speed sensors in the wheel bearing hub assembly
The whole assembly needs to be replaced

Chrysler Town &... | 218 views | 0 helpful votes


Pushing the horn button on the steering wheel doesn't sound the horns , is that what your saying ? Is the air bag light lit on the instrument cluster ? Could be the clock spring ,located in the steering column .Would need to pull the steering wheel . Or could be the integrated power module , Chrysler , jeep , Dodge vehicles have known problems with these modules , all kind of electrical problems .

http://www.chryslerproblems.com/tipm/ Taking to a qualified repair shop mite be your best bet.

Chrysler Town &... | 26 views | 0 helpful votes


Either hose has 2 clamps...one on each end. Dont take off unless car is cool. If its bottom one loosen radiator side 1st and let drain. Be sure to top coolant back off and check overflow when finished....also burp system of air.

Chrysler Town &... | 35 views | 1 helpful votes


TIPM - totally integrated power module probably . Chrysler has a recall on some of their vehicles .
http://www.chryslerproblems.com/tipm/

2008 Chrysler... | 41 views | 0 helpful votes


Probably not. Passive anti-theft systems have been fairly universal since the early 1990s. The system is integrated into the management system and requires the correctly coded transponder key to disarm the system.

Chrysler Town &... | 59 views | 1 helpful votes


You don't. The Item is replaced as a complete hub. They are about $40.00. The bearings are new and greased.

Chrysler Town &... | 29 views | 0 helpful votes


Yes you will need to replace the hub. Unless you have a 20 ton press and arbors and a cup,\ to push studs into., forget it.

Chrysler Town &... | 25 views | 0 helpful votes


I had a 1999 Dodge Grand Caravan in '99. The same van with fewer bells and whistles than yours. It's been a while but if it isn't under the dash in the fuse block on the driver's side, it is in the rectangular black fuse block with the snap off lid under the hood on the driver's side. Good luck.

Chrysler Town &... | 33 views | 0 helpful votes


You need the radio security theft deterrent code, it was given to the original owner with the vehicle info packet, see the dealer for further help.

Chrysler Town &... | 44 views | 0 helpful votes


https://www.transmissionrepaircostguide.com/p0791

Here is a link to the code you have on your car.

Chrysler Town &... | 53 views | 0 helpful votes


The main thing to remember when messing with a Chrysler product newer than 1996 is that you can not interchange modules from one vehicle to another. Does not matter if it is the exact same number or not. All modules are programmed to the VIN at the factory and will not work in any other vehicle. You must use the factory original part or order a new part and have it flashed to the VIN at the dealership.

Chrysler Town &... | 44 views | 0 helpful votes


Hi, Seems that the SKIM (Security Key Immobilizer Module). Try locking and unlocking drivers door, sounds like security system was triggered. If unlocking and locking door does nothing locate (ECU) fuse, (Main) fuse, and (IOD) fuse. If so pull fuses turn key to on position do not start, wait 3 to 5 minutes install fuses and try starting. Please also check battery connections for clean and secure.

2001 Chrysler... | 1,304 views | 0 helpful votes


No reset switch. Hook up a fuel pressure gauge an check pressure . Check electrical circuit , voltage drop testing . are the fuel injectors firing ? Anti-theft system light lit ? anti-theft system problems on some vehicles will disable fuel injectors .

Testing Electric Fuel Pump Problems with Voltage Drop Test

2006 Chrysler... | 482 views | 0 helpful votes

Not finding what you are looking for?

-5,226 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...