Chevrolet Corvette - Recent Questions, Troubleshooting & Support
Looking for info on how to adjust the fuel mixture
That engine runs at low speed, starts and idles on the center carb only. first make sure the carbs are synchronized so the front and rear ones are fully closed at idle, then adjust idle speed and mixture on the center carb. Sweet ride by the way, if you get tired of working on it and want to get rid of it I will take it. LOL
Where is fuse box in
Should be under the drivers side dash.. turn the key on.. turn on either the hazards or turn signal.. the flasher unit is plugged into the fuse box.. you will hear it.. helps locating it.. unless of course this is what you are replacing!
Good luck
Where is the starter located on 89 corvette
The starter is located on the passenger side where the engine mates with the transmission. It's held on by two bolts and there are wire harness that need to be disconnected and are live so you need to disconnect the battery ground first. Good luck and hope this helps. Keep me posted if you need instructions to removing the starter or you can log on to Auto Zone and register free of charge and you can get a print out on how to get the job done with common tools. Be safe friend.
Where is the fuel pump relay and fuse for a 1992 corvette.
You have to take off the passenger side knee bolster for the relay. From the trans tunnel to the door- Fog lamp relay-Courtesy Lamp Relay----Fuel Pump #1 Relay-Horn Relay-Rear Defogger Relay. Fuse is located in the Main Fuse Block Located on the right side of the dash (small panel pops off the far right side) passenger door needs to be open to do this. The fuse is labeled FP 1 and is the furthest fuse left on the second row from the bottom Red 10 amp. Fuel pump is located under the fuel door in the back of the car- you just need to take the door off and you can check for voltages or even replace the pump from there- no need to drop the tank or anything .
The battery keeps draining and
This may be over-simplified, but to find the battery drain: Remove the positive battery cable from the battery and insert an ammeter in series beween battery and cable. If something is draining the battery, it will show on the ammeter. Remove fuses one-by-one until you see a substantial reduction in the ammeter reading. That will pinpoint the circuit that is draining the battery. Then troubleshoot until you find the faulty component, wiring harness, etc. Remember there will always be a little bit of drain because of ECM, BCM, radio memory and stuff like that.
1966 corvette clutch petal adjustment
Pretty sure it should all be on the push rod of the Z-bar linkage. If I remember correctly, you want about 1/4" of pedal travel from the top rest position until you feel resistance from the pressure plate.
Changing front directioal signal bulb on 2000
Turn your ignition on and your headlights. Turn the key off and then the headlights. They should stay open. Open the hood. Remove the rubber 'bump stop' located next to the headlamp on the side that has the bad bulb. Be careful to not change the location of the lock nut.
Now you have a big opening that will allow you to reach down to the rear of the directional signal and remove the socket and bulb by turning counter clockwise. Replace the bulb. I like to put some dielectric compound or at least some vaseline on the base wires of the new bulb.
Test. Reverse procedure for reassembly. Congratulations....... you just saved $70.00!!! Dave
1991 corvette convertible top deck clicks / inop
I have a 1991 convertible Vette and I had a simular problem. The top would release from the deck, but only the driver's side latch would release on the deck lid. What I discovered is a small bracket that is held on by a retaining washer clip and the clip had come off. Went to the hardware store and bought a new one for $ .50 and remounted the bracket. The manual release for the deck is located behind each seat, pull towards the center of the car.
Not finding what you are looking for?
