Chevrolet Corvette - Popular Questions, Answers, Tips & Manuals
Where is the fuel pump relay and fuse for a 1992 corvette.
You have to take off the passenger side knee bolster for the relay. From the trans tunnel to the door- Fog lamp relay-Courtesy Lamp Relay----Fuel Pump #1 Relay-Horn Relay-Rear Defogger Relay. Fuse is located in the Main Fuse Block Located on the right side of the dash (small panel pops off the far right side) passenger door needs to be open to do this. The fuse is labeled FP 1 and is the furthest fuse left on the second row from the bottom Red 10 amp. Fuel pump is located under the fuel door in the back of the car- you just need to take the door off and you can check for voltages or even replace the pump from there- no need to drop the tank or anything .
1966 corvette clutch petal adjustment
Pretty sure it should all be on the push rod of the Z-bar linkage. If I remember correctly, you want about 1/4" of pedal travel from the top rest position until you feel resistance from the pressure plate.
I just got a 2000 Chevy Corvette C5. The front turn signals needed bulbs, after the install the front are on in the off position and off in the on position ???
in your fuse box there should be a round usually silver in color relay that controls the blinking of the turn signal. its where the clicking sound coms from. you need to replace that relay.. "note" if you have installed LED bulbs... Then that is where your having trouble. The LED or [Light Emitting Diode] does not pull enough amps [Load] required to make the relay function properly. it is why when one of the bulbs ...be it in the front or in the rear goes out the remaining one flashes faster. You can either replae the LEDs with regular bulbs, or with LEDs that are designed to be signal bulbs with built in resistors or there is resistors you can add to the + wire to simulate the Load required for the flasher relay to operate properly...
HOW TO REPLACE WATER PUMP ON 84 CORVETTE
Your better off getting qualified tech to do a waterpump.Replacement if you dont no how to do it.Youll cost yourself more headaches and money.Qualified mechanic here giving my time free
Not finding what you are looking for?