Re: Blows fuse at relay on my Yamaha Grizzly 4504x4 2009...
Have you checked the wiring on the relay all the way down to the frame and battery? Sometimes there is a hidden broken and exposed wire that is covered with dirt and makes an issue when it gets wet.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you look at the picture - 29, 30 & 31 are the starter relay, main fuse and probably the bolt that holds it to the frame. When that fuse blows or that relay goes out - it's over. Not going to start. If you have a standard test light - attach the clip end to ground (frame of atv) and then put touch the postivie post of the battery to verify that the light is functional. It will light up if the battery is good. Next -follow the red cable to the starter relay in the diagram. Where it attaches - check for power. With the key off. IT should be live without the key in. It's on standby in a way. If you do not have power at the other end of your positive cable - your cable is shot. If you do - then you will have someone turn the key and check to see if power is coming from the other post off the relay (that would go to the starter and make it engage - if the square standard fuse in that relay is not blown - but power is not coming through when you touch the key - it's probably the relay. Your safety switch among other things can prevent the engine from starting as well - along with loose cables and grounds (always do a thorough check of all wire connections and grounds - one loose ground can mean a nightmare sometimes) - if you give that a try and do not identify the culprit - just comment or reach out and I'll take you through the next steps. All The Best, Justin Lee, 17 South Industries, LLC
Here's a copy with 29, 30 & 31 Link will take you to page as well*
www.grizzlycentral.com > ... > Grizzly Engine & TransmissionMar 12, 2012 - 4 posts
This is a discussion on Grizzly 660 Shifting problem. within the Grizzly Engine ....2005 grizzly 660 gear position sensor problem.
the belt housing is filled with water.
open the drain valve on bottom of housing, drain and let dry for 24 hours. Once the moisture is all gone the belt will stop slipping.
drian engine oil take side cover should be an 8m to 12m depending on the model... the stator might be attached to the cover or might have a mount holding it into place to the fly wheel
get one of these..If you are going to try the repair yourself....
.this is serious, ....
there MIGHT be damaged components that need to be inspected by a professional.
×