SOURCE: Won't Start
do you have compression? for a engine to run you need clean air,compression, good fuel(make sure the fuel has not been there 3 months or more as it will deteriate) and good spark as well as good exhaust as this will cause a back fire if the exhaust valves are not set right.
SOURCE: no front brakes on yamaha atv
if they are drum brakes you may need to adjust the starwheels between the brake shoes. just like old car brakes
SOURCE: no front brakes on 95 yamaha big bear atv
gravity bleed. make sure fluid is always full. crack open the bleeder screw and let the brake fluid drip until no bubbles. Then close bleeder top off fluid and replace cap. Now, pull the brake handle. If there is no pressure or has bleed down, the master cylinder is kaput.
SOURCE: have a 04 yamaha big bear 400. hard to start wont
I have an 01, and it started doing this. I don't remember the circumstances. It's just dirty in the carb I think.
1) Check for water in the gas.
2) Turn off the petcock and drain the carb. turn it back on.
3) Try it.
4) Start it with the choke on and put your hand over the air filter hole. Will cause some back flow.
5) Try again.
Worked for me. Might be dirtier on yours, or have mud in it or something.
947 views
Usually answered in minutes!
×