Transmission slipping or jerking in high range .I have tried replacing the drive belt and the weights in the front clutch with no luck .Is there anything else I can do .
SOURCE: 2004 arctic cat 500 4x4 starter turns doesnt engage starts with pull cord
The starter has to throw it's gear out using centrifugal force. The speed of the starter has to be enough to overcome the spring inside. It is either a little seized and needs to be rebuilt and greased up, or the battery isn't powered up enough to get the right speed to engage properly. In that case clean the battery posts and clamps well, then charge or replace the battery. To know if the battery is bad wait till it is charged... if it still doesn't engage try again with booster cables from your car etc. and see if it suddenly works fine.
SOURCE: 2009 arctic cat 4x4 auto 500
Unless you have a few special tools...flywheel remover, case splitters, crank installer, clutch tool, factory service manual.etc.. TAKE it to a professional!!
1,210 views
Usually answered in minutes!
×