05 yamaha 250 bruin timing marks - Yamaha 2005 Bruin 250

Question edited for clarity.
Question moved from motorcycles to ATV model category.

Turning over has nothing to do with the carburetor! Your battery is flat. It will need charging.

If the carb is leaking, it is because the float is set wrong or the float valve needle isn't seating properly.

Engines only need three things to run.

A supply of clean fresh fuel (not sitting a year)
A Spark at the right time.
Compression.

You say you cleaned the carb **in** carb cleaner, as opposed to *with* carb cleaner. Did you strip it down, check the float for holes, clean the jets and needles?

Question edited for clarity. Add maker.
Question moved to Yamaha Bruin category.

Likely to be a fault with the ignition switch Karen. There is help in the link.

https://www.google.com/search?q=2004+Bruin+350+won%27t+switch+off

..

Factory Service manual, Clymers Manual, Haynes manual

You will need to replace the head gasket. Tightening the head will not work once the oil has found a path to leak out.

bad seal on the crank shaft output where the recoil attaches

sounds like a bad seal on the crankshaft where the pull starter attaches.

check your ground wires,could be a bad coil lead to the plug,a bad coil in the stator,a bad plug?try these things first

sounds like bad ujoints in the rear drive shaft.

refer to owners manual... or google it

what's the oil capacity for 1.9 d Renault Clio x reg