Motorcycles Logo

Related Topics:

How to take off a kawasaki prairie 400 4x4 tire

Cant get the rear right tire off to get to the brakes

3 Related Answers

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Jun 18, 2009

SOURCE: kawasaki 400 zxr 2000

Look for a fuse burnt or a wire unplugged under the seat and by all means ck the bulb.

Ad

vtrktrmn

  • 201 Answers
  • Posted on Sep 22, 2009

SOURCE: how do I take the rear tire off of a 2004 kawasaki nomad

I hope you have a jack... I had to remove the pipes and bags on my 04 vulcan nomad so I remove the cotter pin and pull the axle out of the rear hub. Then removed the spcer and rear brake. slide wheel assy. out of the drive hud on the left (removal of brake and spacer allow this) and drop the tire down. It's not hard...

Testimonial: "thanks for the help I am sure that I can do this now."

Anonymous

  • 6 Answers
  • Posted on May 05, 2010

SOURCE: i have a 2002 kawasaki prairie 650. i think i have

Check the seal behind your water impeller there are o rings back there if one of them goes bad you will leak antifreeze into oil, your impeller is run by the oil pump i believe, you should not see oil in the water also your bike will run fine but when hot will foul the plug with water look for white smoke sometimes and the smell of anti freeze on start up
i have a 400 4x4 doing the same thing new piston rings and top end now lossing water but runs great oil looks real thin
took to the dealer to fix this week will let you know how i make out.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why do my front brakes on my 1997 Kawasaki Prairie 400 4X4 keep locking up

They normally will do that if you have lost the liner or pad, when you go to apply the brake becouse of no pad of drum liner brake pads travels to far before it reaches the rotor when it does get there, piston fully extended and it will lock the wheel
0helpful
1answer

My 2003 Kawasaki prairie 360 when u install the hose from the air box it will only idle u can not rev it up take the hose off and it runs fine

2003 360 Prairie 4x4 cutting out... I'm stumped! - Kawasaki ...

www.kawasakimotorcycle.org > ... > Kawasaki ATV and Mule
Dec 14, 2011 - This 360 4x4 has me stumped. ... 2003 360 Prairie 4x4 cutting out. ....It idles just fine, it has perfect throttle response, it just won't rev without ... 2006 Prairie 4x4 governor prob?
Oct 1, 2009
04 Prairie 360 Knocking when Idling and Belt Light on.
Jan 26, 2009
Older Prairie Tune Up Questions
Sep 19, 2008
Prairie 360 (Limp Mode)
Jan 4, 2005
More results from www.kawasakimotorcycle.org
0helpful
1answer

Will idle & run at slow speeds, bogs down at higher speed.

Prairie 360 revs high but goes slow (45mph) - Kawasaki ATV Forum

www.kawieriders.com > ... > Kawasaki Brute Force/Prairie/Bayou
Oct 27, 2008 - 2006 Prairie 360, wife's ride, polar white, with 26" Swamp Lites on SS108's. ... that it has a low top-speed...45mph is about as fast as they seem to go. ....air cooled motor theres no real performance there, the P360 wts are light ... Can't put 2005 Kawasaki KVF 360 into gear
Jun 30, 2013
Prairie 360 speed/power issue?
Aug 28, 2012
06 Prairie 360, too many rpms???
Nov 30, 2011
2004 Prairie 360: WOT miss
Nov 9, 2011
More results from www.kawieriders.com
0helpful
1answer

Kawasaki forum, I have a 2002 kawasaki prairie 650 4x4 that will not switch into 4 wheel drive. It stays in 2 wheel only. Help please

Honda FourTrax & Kawasaki Prairie 650 ' Outdoor Life

www.outdoorlife.com/articles/gear/.../honda-fourtrax-kawasaki-prairie-6...
Honda decided not only to get into the 500cc-class automatic 4x4 camp, but to do ...by three electronic shifting programs: one for high-speed driving on easy trails; ... this innovation: Kawasaki made the Prairie 650 capable of starting in gear.
Sep 12, 2015 • ATVs
0helpful
1answer

4 wheel drive light flashing on 2008 kawasaki prairie. What does this mean?

Depending on the flashing frequency, it could be the Electronic BRake controller, the 4x4 actuator or the brain.

Look for the service manual online, it has a procedure for checking/cleaning the actuator. It could be stuck with dirt and need a cleaning.
0helpful
1answer

2006 kawasaki prairie 4x4 model kvf 360 c belt indicator light reset

On the right hand side of the ATV just under the gear leaver, you will find a grey and black multiplugs, you will need to swap them. Please see the link below. KAWASAKI 360 PRAIRIE BELT RESET
3helpful
1answer

How do I take the rear tire off of a 2004 kawasaki nomad

I hope you have a jack... I had to remove the pipes and bags on my 04 vulcan nomad so I remove the cotter pin and pull the axle out of the rear hub. Then removed the spcer and rear brake. slide wheel assy. out of the drive hud on the left (removal of brake and spacer allow this) and drop the tire down. It's not hard...
Not finding what you are looking for?

247 views

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...