RTO ATVs - Page 3 - Recent Questions, Troubleshooting & Support

Check the fuel filter. It could be collapsing.

clean idle jet. If that does not do it. back out fuel mixture screw 1/4 turn

my artic cat did this found that the carb was dirty

get a new one

when engines not running turn the gas off . And it sounds like you need to adjust your throttle pin that goes into the carb take the clip off the pin and move it down one good luck

sounds like your carb float is stuck and your needle and seat is open allowing the bowl to fill with gas and run out the overflow. take off the bottom bowl of carb and check to see if the float has a hole in it.

try backing out your fuel/air mixture screw 1/2 a turn. This should be 3 turns out from seat.

does starter turn? got spark ? gas? ignition on ? help me help u?

i would adj valves 1st and go from there. rings maybe stuck if it has sat a while w/o being started. run a compression test on it should have something at least. no compression doesnt sound right to me. if so rings stuck can be freed if so ,sometimes fixes it ,sometimes breaks it

adj valves ? prolly why!

This is a Lynn Edwards hand drawn schematic (scroll down)

http://forums.atvconnection.com/chinese-quads/323218-150-cc-taotao-wont-start-no-spark-2.html

This should be exactly what you need. Took a while to find it.

Kelly

ok ! what you want to know?

details my man need details. bike ran before now. ? how long u had it . ? make model and serial # and year please. how olds battery? wires to battery real clean? loose on terminals? corrosion ? help me help you !

honda forums is the place to go

btm is neutral .all the way down i believe. all up from neutral position pull brake lever and push button to put in reverse ? from neutral pos. reverse is past neutral only gear lower than neutral is reverse

bad fuse, plug,plug wire,ignition coil,ignition coil wiring,badpick up sensor,faulty cdi,cheers

need more info dude do mean drive belt as most are liquid cooled