20 Most Recent
Polaris 2010 Sportsman 400 H.O - Page 9 Questions & Answers
2005 Foreman 500. Why doesn't it start?
Ok,, first, If you did not get GENUINE Honda replacement parts for your carb, get the junk out and put the original parts back in, NOW !!!- Take this carb to a PROFESSIONAL MECHANIC and have him clean and set it!!!
12/16/2021 4:14:59 AM •
ATVs
•
Answered
on Dec 16, 2021
Does 10 ohms matter in a trigger coil
Check your meter for a zero reading. If your meter can't be zeroed or does not have a relative measure then subtract the reading you get when you touch probe tips. Regardless, a few ohms is not likely the problem.
Check valve clearance. Maintenance schedule shows to check every 100 hrs. I believe clearance is 0.006 in. cold for both intake and exhaust.
12/11/2021 5:02:32 PM •
ATVs
•
Answered
on Dec 11, 2021
Honda Trx 500 electrical pulse generator
Okay I see your answer. I will research this tomorrow but my first instinct is that two volts is probably right. The pulses are low voltage and trigger the spark electronically using low voltage power which is then amplified. .
12/3/2021 9:24:05 PM •
ATVs
•
Answered
on Dec 03, 2021
Yamaha 4x4 big bear won't start
limited info generic answer--check fuses-breaker -ign switch -kill switch--solenoid--neutral switch --harness connector
11/20/2021 3:14:03 AM •
ATVs
•
Answered
on Nov 20, 2021
I got a Honda rancher 350 I was riding itan it shut off idk what cause itto do it
First, make sure the gas tank is full!! Install a NEW spark plug. Make sure the kill switch is in the ON position. If this doesn't do it.. Time for a little more serious investigation.. Is the carburetor getting gad to it?.. there is a little screw in the bottom of the carb(flat head?).. loosen it a little (a couple turns and gas should run out),,, if it does shut the screw off.(this is good) If not, you have found the problem.
Beyond this, you need a professional mechanic to help you.
11/12/2021 5:55:48 PM •
ATVs
•
Answered
on Nov 12, 2021
2013 Honda Rubicon TRX500FA, Starting in Gear / Neutral Positions
When starting in gear there is a switch , controlled by the front brake lever to avoid over revving, make sure the front brake lever is fully applied when starting in gear , if the engine starts to run rough disengage the brake lever fully, if rough running continues then likely switch needs replacing/servicing
11/11/2021 1:42:24 PM •
ATVs
•
Answered
on Nov 11, 2021
Not finding what you are looking for?