20 Most Recent RTO 200cc Full Size Four Wheeler ATV - Page 3 Questions & Answers

What is it be more specific yr make model If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

The valve may be off a bit get the valve specs and check it usually the intake valve that causes that you will have compression but it it will stay open just enough that it won't start If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Carb is plugged or you need to go up a couple sizes on the main jet in the carb it's running to lean needs more fuel If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Try changing your fuel filter If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Check spark clean the carb check valve clearances if none of those you have an electrical problem If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Most the parts are compatible really the only differance is the plastics If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

91 octane pump gas that you put in your car If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Don't have pic but I can tell you were it is it a square bolt at the base off the motor mount If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

It's in the back of the engine a major pain if starter turns and doesn't engage that's even harder then you have a bad one way bearing they are around 300 bucks and you have to pull the back of the engine off to change it hope it just the starter If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Sound like it may have a plugged filter or fuel injector If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Check the starter and the starter solenoid if those are good your starter button may be bad If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Smack the starter with a hammer or a wrench if the starter isn't turning over then it's bad if it does crank and won't start your CDI may be bad you've all ready replaced the little stuff sounds like it your starter is bad hope it not CD I if it is replace the stator as well and buy them on ebay it will save you a ton of money If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Check for spark if it has spark your carb may be dirty or not jetted right if it's not your carb or spark your valves may need to be adjusted If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Remove and clean the valve coming from the tank

Check for corrosion at the battery terminals

fuel runs from the tank to the carb I figure. not much to it.

did you check the float in your carb?

.035" or refer to owners manual

1st. change oil and filter.. use 10-40.. if that doesn't quiet them... .0025"-.003" on intake .004" - .005" exhaust should do it... if they are too tight,,it won't idle down fast or well.... or excessively tooo tight -won't start..too loose they rattle or if there is a lot of wear.. the rocker arms may need replacing

voltage regulator... new battery (first) meter should read 13+ volts over 4k rpm and up