kawasaki ATVs - Page 5 - Recent Questions, Troubleshooting & Support

10w40 is a safe bet. Conventional

Possible vacuum or intake leak

Your alternator/regulator/rectifier is blown or a bad connection within these components

Sounds like a vacuum leak or something is binding open. Spray ether or brake klean around all connections to see if there are any leaks and/or open it up again and check for sticking parts or misplaced springs

Make sure the needle/seat spring is still there. also make sure your fuel filter is clean enough to keep up to your carb's new thirst

The first things I would check are seized brakes and then transmission condition/fluids. The auto has 2 clutches I believe. Make sure everything is full on fluids

Could be an electrical problem. If it doesn't sense the neutral position signal it will not go into reverse. If your neutral light comes on then it may be a loose connection after the light. This is on of a few things to check out first

whats the question?

Did you check the frame rail by your left toe? it may have been painted over.

I believe its mechanically set so no need to re time it when replacing electrical components.

buy a replacement barrel and key off ebay,be lots easier

Sounds like not getting petrol, clean petrol tap to get a good flow and clean and strip carburetor the needle and seat could be clogged any way clean and blow out jets and holes with compressed air put back together and away you go.

I suggest you check the exhaust isn't partially blocked and then if OK ensure the cam timing, valve clearances, etc. is correct.

very good I need help that they gave a kawasaki bayou of the 94 4x2 300 and I need to know where the numeration or vin of the chassis and engine have if they can help me they are grateful

No, unfortunately sorry.

YES!

Check the tuning on carburetor.

Did you figure this problem out? I have the same problem I think it may be the tps?

first I'd clean the carb, new spark plug. I've seen a bad cdi cause that but thats the last thing I'd check cause $$$

blocked main jet fuel flow problem incorrect float level