Scanners R Us
Steve Dyer posted an answer for this Fujitsu fi-5900C Pass-Through Scanner:
"you need the detail code to e18 to determine the exact error. First generate the error..."
Steve Dyer posted an answer for this Canon Office Equipment & Supplies:
"Firmware on this scanner is terrible Had this problem myself, Scanner needs to see the ADF..."
Steve Dyer posted an answer for this Canon DR-9080C Path-Through Scanner:
"Check the inadequate Cable harness (normally purple loom) under the metal lifter . You..."
Steve Dyer posted an answer for this Kodak i4200 - document scanner:
"Calibration of the Multi-feed (UDDS) is the only thing the user can do . Image Calibration..."
Steve Dyer posted an answer for this Fujitsu fi-5900C Pass-Through Scanner:
"I think you mean E1A which is the code of Death for a Fujitsu 5900C It normally..."
Steve Dyer posted an answer for this Fujitsu fi-5900C Pass-Through Scanner:
"Lift the Skimmer unit up so the scanner is in the manual feed mode. Feed a Document into..."
Steve Dyer posted an answer for this Fujitsu fi-5900C Pass-Through Scanner:
"You need the detail code after the display has posted the E18. This can be achieved by..."
Steve Dyer posted an answer for this Kodak i1440 Pass-Through Scanner:
"This Scanner has no Firmware built into it. It relies on the Driver to supply this on the..."
Steve Dyer posted an answer for this Kodak Digital Science 3520DP Path-Through Scanner:
"replace interlock, gone high resistance"
Steve Dyer posted an answer for this Kodak i1860 - document scanner:
"Windows all programs , Kodak Scan validation tool Twain ,Setup, Device, Diags , Logs tab."
Steve Dyer posted an answer for this Kodak Office Equipment & Supplies:
"Replace firewire card in the pc."
Steve Dyer posted an answer for this Kodak 3000 DSV Film Scanner (35 mm), Film Scanner (16 mm):
"You have to Change the scanner vendor name to MS7000 and then use the Minolta Twain driver..."
Steve Dyer posted an answer for this Kodak i260 Duplex Color Scanner:
"Clean Optical path to camera lenses back and front, then Calibrate through the Kodak..."
Steve Dyer posted an answer for this Kodak I260 Captiva IA-Express Path-Through Scanner:
"If you start scanning Documents over 17 inch, then its best to swap out the 64mbyte for a..."
Steve Dyer posted an answer for this Kodak I260 Captiva IA-Express Path-Through Scanner:
"They can fix it:- www.Responsets.co.uk"
Steve Dyer posted an answer for this Kodak Digital Science 3520DP Path-Through Scanner:
"Yes. Reccommend:- www.Responsets.co.uk"
Steve Dyer posted an answer for this Kodak Digital Science 4500D Path-Through Scanner:
"Mains Transformer inside the scanner is vibrating."
Steve Dyer posted an answer for this Kodak Digital Science 3590C Path-Through Scanner:
"No drivers for Vista"
Steve Dyer posted an answer for this Kodak i40 Path-Through Scanner:
"Face down lamp error, check lamp/ballast connections. If its still a problem replace the..."
Steve Dyer posted an answer for this Kodak i160 Path-Through Scanner:
"The Ballast (inverters) for the lamps are drawing to much current and killing the main CPU..."
Steve Dyer posted an answer for this Kodak i160 Path-Through Scanner:
"If its the Diagnostic Key you require?? This is only Available to Kodak Authorised Repair..."
Steve Dyer posted an answer for this Kodak i40 Path-Through Scanner:
"Error 8 = Face up light check failure. Check Top Lamp is lighting up and not Flickering...."
Steve Dyer posted an answer for this Kodak i40 Path-Through Scanner:
"8 Face up light check failure is the only code listed, not "88" for this model. If code 8,..."
Steve Dyer posted an answer for this Fujitsu M4099D/FI-4990C Scanners:
"Attributed to paper sensor problems. Clean the little square and round paper sensors under..."
Steve Dyer posted an answer for this Fujitsu M4099D/FI-4990C Scanners:
"When the scanner scans the first image it will bring in via a set of solenoids a..."
Steve Dyer posted an answer for this Fujitsu fi-5750C Flatbed Scanner:
"Open up the ADF ****. Remove Two Silver screws holding front of top cover. Remove screw..."
Steve Dyer posted an answer for this Kodak 3000 DSV Film Scanner (35 mm), Film Scanner (16 mm):
"You need to convert it to a Minolta MS6000 to use other software packages and download the..."
Steve Dyer posted an answer for this Kodak i260 Duplex Color Scanner:
"Not a Vista Compatible Kodak tested machine. But may work on Vista 32 bit platform. Vista..."