Anonymous posted an answer for this Cisco (VG248) Gateway:
"Simple,, its your filters. do you have one or two fiters fitted. one at the wall and one..."
Anonymous posted an answer for this Frigidaire GLEH1642DS Front Load Stacked Washer/Dryer:
"it is unbalanced, you must contact your supplier and have him fit it properly. do not do..."
Anonymous posted an answer for this Tomtom ONE GPS Receiver:
"try swithching device off then back on. tap volume bar at bottom. if this does not work..."
Anonymous posted an answer for this Tomtom GO 910 GPS Receiver:
"you dont say what you want to delete, normally put your device in the cradle provided and..."
Anonymous posted an answer for this Hotpoint Washing Machines:
"Pump impellor pin broken"
Anonymous posted an answer for this Hotpoint Aquarius WMA56 Front Load Washer:
"cut it through gently without damaging the waste pipe, replace with electric tie."
Anonymous posted an answer for this Hotpoint Washing Machines:
"Leave screws alone. Solenoid on cold water inlet valve faulty"
Anonymous posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"Faulty water valve, check cold inlet valve solinoid"
Anonymous posted an answer for this Hotpoint Aquarius WD63 Front Load Washer/Dryer:
"pull it out as far as it will go. Look inside you will see a clip at the top. depress this..."
Anonymous posted an answer for this Zanussi FC1200W Front Load Washer:
"You dont say what your original problem was but the ball is there to act like a float."
Anonymous posted an answer for this Hotpoint Aquarius WF000 Front Load Washer:
"Think your belt was allready on the way out and you will need a new one. Just a..."
Anonymous posted an answer for this Washing Machines:
"I'm afraid you will need to replace the bearings and seals. Shop around for decent prices...."
Anonymous posted an answer for this Washing Machines:
"try www.lpdlpd.co.uk They deal with most maytags and are a very helpfull company. John"
Anonymous posted an answer for this Washing Machines:
"put the stamped lettering on the bearings facing outside"
Anonymous posted an answer for this Amana LWA40A:
"without really looking at it i would have to say it Sounds like water seal gone in drum...."
Anonymous posted an answer for this Kenmore HE2 Plus Front Load Washer:
"First of all check there is no coin or similar object stuck between the barrel and outer..."
Anonymous posted an answer for this Kenmore HE2 Plus Front Load Washer:
"Open the door so it is 90degrees from machine, see if it is upright. if not undo the door..."
Anonymous posted an answer for this Washing Machines:
"Have you checked for broken drive belt??"
Anonymous posted an answer for this Kenmore Washing Machines:
"Check your inlet pipe on cold water supply, When you dissconnect look inside where pipe..."
Anonymous posted an answer for this Hoover AAA160 Front Load Washer:
"If you have checked condition of carbon brushes in motor and they are ok.Check the valve..."
Anonymous posted an answer for this Haier HWD1000:
"Could be water valve stuck open/ malfunction on coil. or possibly level control valve."
Anonymous posted an answer for this Kenmore Elite Oasis 27052 Top Load Washer:
"Check that the dispenser is clean, it may be gunged up with black gunge, use soda crystals..."
Anonymous posted an answer for this Hotpoint WMA64 Front Load Washer:
"draw off the spider with a pulley extractor,"
Anonymous posted an answer for this GE Profile Prodigy WPSE4200A:
"Check the mounting points for tightness on bolts or you may have a broken retainer spring...."
Anonymous posted an answer for this Coffee Makers & Espresso Machines:
"Dont think its the pump. More likely to be a seal"
Anonymous posted an answer for this Ariston Technologies AWD120 13 lb. Washer / Dryer Combo:
"Well it depends on how old your machine is, if eveything else is fine then replace it. The..."
Anonymous posted an answer for this Microwave Ovens:
"The cost of repairing the micro wave will out cost the replacement value. If its new then..."
Anonymous posted an answer for this Hotpoint WMA44 Front Load Washer:
"probably the solenoind/coil or ETA relay faulty"
Anonymous posted an answer for this Indesit W 123 Front Load Washer:
"Loose mounting points or broken pins. If not that then possibly drum shaft could be..."