i have problems just like everybody eles
Anonymous posted an answer for this 2003 Jeep Grand Cherokee:
"it sounds like your air inlet sensor is going out..not changing the mixer"
Anonymous posted an answer for this 1995 Jeep Grand Cherokee:
"try changing the crank shaft senor around the bell housing on the driver side"
Anonymous posted an answer for this 1996 Jeep Cherokee:
"crank shaft senor dead ..driver side around the bell housing ..very small ..50 to 100 $"
Anonymous posted an answer for this 1996 Jeep Grand Cherokee:
"check an see if you have gas coming to the motor if you have no gas than change the crank..."
Anonymous posted an answer for this 1985 Jeep CJ7:
"check an see if you have crank shaft sensor it should be around the bell housing lip where..."
Anonymous posted an answer for this 2002 Jeep Liberty:
"air sensor for mixing gas an air is bad....need to be change."
Anonymous posted an answer for this 1998 Dodge Neon:
"have you try hot wire straight to the fans to see if they work... you also have temp..."
Anonymous posted an answer for this 1994 Mitsubishi Galant:
"you can try a tune up first or you can have your compression check you can have a crack..."
Anonymous posted an answer for this 1994 Mitsubishi Galant:
"the switch that the ignition turn is no good ...or the tip of the ignition that goes into..."