1
Anonymous posted a question about Kenmore Oasis HE 27082 Top Load Washer:
"why does my Kenmore Oasis HE shake violently during the spin cycle?"
Anonymous
Anonymous posted an answer for this Whirlpool Washing Machines:
"Just turn off the water, remove the hoses and unplug it, then bring it out away from the..."
Anonymous
Anonymous posted an answer for this Whirlpool Ultimate Care II LSQ9549L Top Load Washer:
"It is probably reverse thread, so you are probably turning the wrong direction."
AnonymousAnonymous posted an answer for this Whirlpool Washing Machines:
"Either the transmission is bad, or more likely the agitator dogs are broken. If you pull..."
AnonymousAnonymous posted an answer for this Kenmore Washing Machines:
"The agitator dogs may be broken or the transmission could be bad. Try checking the..."
Anonymous
Anonymous posted an answer for this Kenmore 24032\24036 Top Load Washer:
"If it sits there with water and doesn't drain or spin, it thinks the lid is open. Try..."
AnonymousAnonymous posted an answer for this Kenmore Energy Star 44092 Front Load Washer:
"The oil is coming from the transmission. You should also check to see if there is any..."
AnonymousAnonymous posted an answer for this Kenmore Washing Machines:
"The washer thinks the lid is open. Either your lid switch is bad or it is not being..."
Anonymous
Anonymous posted an answer for this Kenmore Elite Oasis 27052 Top Load Washer:
"If it also tends to walk around, there are pads under tub supports that tend to wear out..."
AnonymousAnonymous posted an answer for this Kenmore Washing Machines:
"More than likely, it is in the water pump. Tip your washer back and remove the pump. It is..."
Anonymous
Anonymous posted an answer for this Kenmore 15864/15862 Top Load Washer:
"This is either a coupler kit needing to be replaced or a transmission. You will see the..."
AnonymousAnonymous posted an answer for this Kenmore Washing Machines:
"Your coupler might be bad, even if it does agitate. Also, by removing the transmission,..."
AnonymousAnonymous posted an answer for this Kenmore Washing Machines:
"The lid switch is either bad or not being engaged."
AnonymousAnonymous posted an answer for this Kenmore Washing Machines:
"Check the lid switch. It is either bad or not being activated."
AnonymousAnonymous posted an answer for this Kenmore 24032\24036 Top Load Washer:
"If it agitates but doesn't spin, it is probably the lid switch. Check to see if you get a..."
Anonymous
Anonymous posted an answer for this Whirlpool LSB6200KQ Top Load Washer:
"Either the transmission is out or the agitator dogs are broken. You can tell if the..."
AnonymousAnonymous posted an answer for this Washing Machines:
"Your mixing valve is probably clogged. Remove it, clean it and if that doesn't work,..."
Anonymous
Anonymous posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"If the bearings are out, you don't have to replace the entire outer tub. You can replace..."
Anonymous
Anonymous posted an answer for this Kenmore Elite 45986 Front Load Washer:
"Mixing valve should lock out the hot water when on the cold water setting. Either your..."
Anonymous
Washing Machines 18 answers
