Dedicated IT professional
Anonymous posted an answer for this Cisco Computers & Internet:
"allow tcp ports 6881-6999 only."
Anonymous posted an answer for this Computers & Internet:
"create a vlan and add a port into that vlan and connect a pc into that vlan do the same..."
Anonymous posted an answer for this Cisco Catalyst 2908 (WS-C2908-XL) Networking Switch:
"check the vlan settings of the port on the switch to where the AP is connected, and check..."
Anonymous posted an answer for this CISCO877-M-K9 - 877 Integrated Services Router - router:
"see this excellent guide http://www.cisco.com/en/US/products/hw/routers/ps221/products..."
Anonymous posted an answer for this Cisco (VWIC-2MFT-E1) Modem:
"open up the covers at it may be a fan that is not visible or the rpm of the fan is not..."
Anonymous posted an answer for this Cisco 857W (882658019555) Router:
"connect to the router. in the config there will be a line that reads something like chap..."
Anonymous posted an answer for this Cisco 2610XM Router:
"reload a new image using the serial process via serial port"
Anonymous posted an answer for this Cisco Aironet 1131AG 802.11a, 802.11g/b (746320933474) Wireless Access Point:
"check that you have enough power on the PoE to power up both radios. Switch one off for..."
Anonymous posted an answer for this Cisco Catalyst 3750 Switch - Software Configuration (doc-7816180):
"switch the fibre rx and tx around on one side of the link"
Anonymous posted an answer for this Cisco AIRONET 1200 802.11a, 802.11b (air-ap1220b-a-k9) Wireless Access Point:
"check that the SSID is broadcasting etc. do a debug on the authentication and you should..."
Anonymous posted an answer for this Cisco 805 Router:
"the full instructions are here:..."
Anonymous posted an answer for this Cisco Catalyst 3560-24PS Switch:
"connect to switch and type in show interface status"
Anonymous posted an answer for this Cisco PIX Firewall 506E:
"reload a new boot rom image"
Anonymous posted an answer for this Cisco Catalyst 2950 24x10/100 Mbps Networking Switch:
"copy tftp://.... flash:/...."
Anonymous posted an answer for this Cisco ASA 5510 Firewall:
"nat pool limit being reached. enable extendable natting or create a many to one nat..."
Anonymous posted an answer for this Cisco Aironet 1242ag 802.11a/b/g Wireless Access Point:
"create a new vlan (eg vlan 10) then ensure that the ethernet port is the same bridge group..."
Anonymous posted an answer for this Cisco ASA 5510 Firewall:
"connect your laptop to the asa5510 using a cross over cable"
Anonymous posted an answer for this Cisco Catalyst 6509:
"you need to upgrade the dram of the unit or the processor board"
Anonymous posted an answer for this Cisco Catalyst 3548XL Enterprise Edition Networking Switch:
"you need to interupt the boot process, by using a console cable and interupt boot. Then do..."
Anonymous posted an answer for this Cisco 1841 Router:
"once in enable mode, goto config mode. then select interface, i.e. f0/0 and then type in..."
Anonymous posted an answer for this Cisco Catalyst 4506 48-Port Switching Module (913764):
"shut down the port and then no shut the port."
Anonymous posted an answer for this Computers & Internet:
"connect the blue cisco cable to the console port of the router concerned. Then using a pc..."
Anonymous posted an answer for this Computers & Internet:
"Send me the configs from both routers and I will look at it for you and advise. Sounds..."
Anonymous posted an answer for this Cisco Catalyst 2950 24x10/100 Mbps Networking Switch:
"Just configure your 4 scopes on your DHCP server, and as long as your server is VLAN..."
Anonymous posted an answer for this Cisco Catalyst 2908 (WS-C2908-XL) Networking Switch:
"Try using tera term and see if that works"
Anonymous posted an answer for this Brother MFC-5440CN All-In-One InkJet Printer:
"start at www.cisco.com"
Anonymous posted an answer for this Cisco Aironet 1131AG 802.11a, 802.11g/b (746320933474) Wireless Access Point:
"Sounds like authentication/encryption connectivity issues. Post your config and ill check."
Anonymous posted an answer for this Cisco Aironet 350 Series Wireless Building-to-Building Kit (AIR-SSB350-J-K9) 802.11b Wireless Bridge:
"If nothing else has changed with the configuration, then I suspect that you are..."