Always here to help!
Anonymous posted an answer for this 2005 GMC Sierra 2500HD 4WD:
"The incoder on the side of the transfer case needs to be replaced. Check with GMC - they..."
Anonymous posted an answer for this 1997 Ford Contour:
"Internal Mechanical issue! Take back to the shop that rebuilt it. By chance did you get a..."
Anonymous posted an answer for this 2004 Ford Freestyle:
"No you either need a new switch or the Reastat needs replaced."
Anonymous posted an answer for this 2002 Volkswagen Beetle Turbo S:
"Possible crank sensor"
Anonymous posted an answer for this 2003 Chevrolet Monte Carlo:
"Look in the Owners Manual... IT should say how to change the alarm settings. IF you cant..."
Anonymous posted an answer for this Chevrolet Cars & Trucks:
"80 is on the high side for those... possibly a sending unit issue"
Anonymous posted an answer for this 2008 Saab 9-3:
"They need to be set to the computer in your car. The remotes are generic... BUT Maybe it..."
Anonymous posted an answer for this 1994 Honda Accord:
"No You will need to change the Hubs THEN the brakes to fit the hubs. But changing the..."
Anonymous posted an answer for this 2002 Oldsmobile Bravada:
"Either 32 or 36 - then you need 15mm to take hubs of the backside."
Anonymous posted an answer for this 2001 Honda Civic:
"It is a computer issue. You need to take it to a shop and have the codes cleared! As far..."
Anonymous posted an answer for this 1993 Geo Metro:
".045"
Anonymous posted an answer for this 1998 Ford Explorer:
"You need a BIG Hammer! It is oxidized to the steel! Put one lugnut on with a few..."
Anonymous posted an answer for this 2008 Ford F-150:
"Could be the switch or the controller motor on the transfer case."
Anonymous posted an answer for this 1997 Pontiac Sunfire:
"Did you change the pump? It may be drawing too much current and causing the fuse to..."
Anonymous posted an answer for this 1999 Pontiac Sunfire:
"Check your rear calipers (actuator calipers - the parking brake side will stick and will..."
Anonymous posted an answer for this 2003 Ford Windstar:
"Check and see if your alternator is charging Low voltage will cause those lights to come..."
Anonymous posted an answer for this 1994 Pontiac Grand Prix:
"You need to set the parking brake, Turn the key on let it sit like that for 10 mins. the..."
Anonymous posted an answer for this 2001 Pontiac Montana:
"Sounds to me like it is time to replace the switch"
Anonymous posted an answer for this 1984 Chevrolet S-10:
"A Bad ground"
Anonymous posted an answer for this 1984 Chevrolet S-10:
"If it is for that truck it will be fine, BUT the computer does not have a whole lot of..."
Anonymous posted an answer for this 1993 Lexus GS:
"Prob needs a regulator"
Anonymous posted an answer for this Chevrolet Cars & Trucks:
"Call LKQ or Jasper Give them the year make and model... they will tell you which ones will..."
Anonymous posted an answer for this Oldsmobile Cars & Trucks:
"Poss crank sensor or ignition mod. Dont remember which terms to cross with the paper..."
Anonymous posted an answer for this 1996 Chrysler Cirrus:
"Sounds like it is a rear wheel bearing going bad. Jack it up and spin each wheel..."
Anonymous posted an answer for this 2005 Pontiac Grand Prix:
"Did you clear the codes after you replaced??? Unplugging battery does NOT always work"
Anonymous posted an answer for this 1994 Oldsmobile Bravada:
"Yes it will fit!"
Anonymous posted an answer for this GMC Cars & Trucks:
"Unhook the line and blow out with air compressor. The fluid corrodes and will clog them!"
Anonymous posted an answer for this 1988 Ford F 250:
"Check front axle U joints out next to the wheels Jackit up and check your wheel bearings..."
Anonymous posted an answer for this 1991 Chevrolet C1500:
"Could be your turn signal switch! The brake lights in this run through the turn signal..."
Anonymous posted an answer for this 1984 Chevrolet S-10:
"No on something that old... as long as your Carb is tuned right... your emissions will..."
Anonymous posted an answer for this GMC Cars & Trucks:
"IF it is a mechanical fuel pump... Poss worn out Cam Shaft... not making the pump work!"