2Professional swimming pool repairman since 1994.
Steve Slater posted an answer for this Hayward Pool & Spa:
"Underneath the back cap on motor"
Steve SlaterSteve Slater posted an answer for this Hayward Pool & Spa:
"Check for proper supply voltage and that the impeller moves freely. If these are good then..."
Steve Slater
Steve Slater posted a question about Nissan Cars & Trucks:
"2011 Nissan Pathfinder, two key fobs and neither one will work unless I am right next to..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Bottom right corner. Take the door off the heater and the first thing you see front and..."
Steve SlaterSteve Slater posted an answer for this Raypak Pool & Spa:
"This is very common with Raypak. What you hear is the way the air flow drafts through the..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Something is broken inside the filter. You will need to open up or take the top off the..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Many salt systems work on a 15 minute time clock, i.e. if set to 50% it will run for 7.5..."
Steve Slater
Steve Slater posted an answer for this Solar Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c:
"should ask, Do you have automation or external remote? if no..take off remote setting by..."
Steve SlaterSteve Slater posted an answer for this Solar Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c:
"On Rheem gas fired pool heaters SNS is a temp sensor failure. 1. Water temperature is..."
Steve SlaterSteve Slater posted an answer for this Solar Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c:
"This is a failure measuring the temp of water leaving the heater, it has exceeded..."
Steve SlaterSteve Slater posted an answer for this Solar Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c:
"Agree, start with filters. Also check for clogged pump impeller."
Steve SlaterSteve Slater posted an answer for this Solar Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c:
"1) common problem for this heater. Likely the pilot is igniting but the gas valve is not..."
Steve Slater
Steve Slater posted an answer for this Jandy AquaLink RS2/6 All Button Dual Equipment - :
"Double check to make sure he put the sensor on the inlet side of the heater. Sounds like..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Check for a clog, check valve malfuntion, etc. If the pump cant discharge it could trip..."
Steve SlaterSteve Slater posted an answer for this Raypak Pool & Spa:
"If your lucky its leaking from the drain plug or pressure switch. Take the sides off the..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Not familiar with this model number but there should always be about 11" of freeboard give..."
Steve SlaterSteve Slater posted an answer for this Hayward Pool & Spa:
"Not much info to go by here Patty. A gas fired heater needs spark and fuel to ignite. We..."
Steve SlaterSteve Slater posted an answer for this Leisure Pool & Spa:
"Top side control. 90% sure by your description of problem. Buy the topside, plug it in and..."
Steve Slater
Steve Slater posted an answer for this Hayward H Series Pool & Spa Heater 400k Btu Propane Gas Milivolt Ignition H400p1:
"Gas valve. Gas valves will often stick in the closed position especially after sitting..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Water at the sensor has reached an unsafe tempurature. Check for proper water flow. There..."
Steve SlaterSteve Slater posted an answer for this Pentair Pool & Spa:
"It may be more of a mechanical problem than programing. There is typically a switch on the..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"After draining a spa it is common to get an air lock in the plumbing. Depending on the..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Charles, sorry I just re-read your question. The click you hear is likely a contactor if..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Does the breaker trip instantly or does it take a minute? If there is a delay i would..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Sounds like the oring on the diverter valve has failed. It can be an easy fix with a..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Not much info here but SL could be the mode setting. Typically modes are SLEEP, ECONOMY..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"This can be normal depending in the settings. It may continue to run for upto 15 minutes,..."
Steve SlaterSteve Slater posted an answer for this Pool & Spa:
"Sounds like low speed isn't providing enough water flow to close the pressure switch that..."
Steve SlaterSteve Slater posted an answer for this Waterco Pool & Spa:
"Leave 10"-12" empty space above sand (freeboard)."
Steve Slater
Steve Slater posted an answer for this Sta Rite MaxETherm 200000 BTU Heater Natural Gas:
"Yes. 99% chance you will need an exchanger core."
Steve SlaterSteve Slater posted an answer for this Century Pool & Spa:
"This is an unusual request for this motor, I am curious what has brought you to the..."
Steve Slater
Pool & Spa 72 answers
