Master of Technology
Daniel MacDonald posted an answer for this 2006 Motorhispania Arena 125 Pro Racing SuperMotard:
"Check the ignition components. Spark plug, plug wire, coil. ect."
Daniel MacDonald posted an answer for this Motorcycles:
"Bad crank seals cause the bike to idle weird if the seal is on the ignition side due to..."
Daniel MacDonald posted an answer for this Yamaha Motorcycles:
"You will have to remove the carburetor, then remove the intake manifold boot (what the..."
Daniel MacDonald posted an answer for this 2006 Motorhispania Arena 125 Pro Racing SuperMotard:
"Things to check, pickup coil, ignition coil, plug wire/cap and spark plug. Start with a..."
Daniel MacDonald posted an answer for this 2006 Piaggio Fly 50 2T:
"No, nor does it have a 02 sensor."
Daniel MacDonald posted an answer for this Motorcycles:
"Under the plastic ahead of the handlebars."
Daniel MacDonald posted an answer for this 1997 Honda CBR 600 F(3)V:
"http://i28.photobucket.com/albums/c204/jmespe1/can1.jpg"
Daniel MacDonald posted an answer for this kawasaki 2013 Mule 600:
"Test the fuel pump. May have a hole in the diaphragm."
Daniel MacDonald posted an answer for this Motorcycles:
"Red wires are the high beams, Red/white the dipped, and the system is switched ground."
Daniel MacDonald posted an answer for this TEIN Mercedes-Benz 2003-2005 C230 Kompressor W203, Kompressor 4Dr Sedan, Exc. Wagon Super Street Damper Kit OEM Upper Mount, DSG00-KUAS2:
"Behind the front bumper/grille ahead of the radiator."
Daniel MacDonald posted an answer for this 2008 Aprilia RS 125:
"It means that your oil is low or the oil level sensor is faulty. 2 cycle injection oil."
Daniel MacDonald posted an answer for this Harley Davidson Motorcycles:
"Orange wire to "12v Orange" wire. Black wire to "GND BK" Yellow/Whiye wire to "Y/W"..."
Daniel MacDonald posted an answer for this Motorcycles:
"Open tool box, at rear of seat, with key and unhook or unbolt the seat from inside tool..."
Daniel MacDonald posted an answer for this Motorcycles:
"Open tool box, at rear of seat, with key and unhook or unbolt the seat from inside tool..."
Daniel MacDonald posted an answer for this Chevrolet Cars & Trucks:
"Under trunk lining. http://parts.nalleygmc.com/images/parts/gm/fullsize/0211261N08-010.JPG"
Daniel MacDonald posted an answer for this Chevrolet Cars & Trucks:
"Under the trunk lining...."
Daniel MacDonald posted an answer for this Honda Motorcycles:
"The best way ever! .........."
Daniel MacDonald posted an answer for this 2009 AJS RegalRaptor DD125E8 Silverhawk:
"I'm assuming you mean schematic...."
Daniel MacDonald posted an answer for this Motorcycles:
"Usually the cable breaks at the very end where the barrel is attached. if so there are..."
Daniel MacDonald posted an answer for this Motorcycles:
"I pretty sure it is in front of the handlebars under the plastic."
Daniel MacDonald posted an answer for this 2002 Buell Blast:
"Clyinder and head: In a cross patern Tighten bolts to 8-10 ft-lbs (11-14 Nm). Tighten..."
Daniel MacDonald posted an answer for this 2002 Buell Blast:
"im trying to find out what the torque specs are for the over head valve cover and top head..."
Daniel MacDonald posted an answer for this Suzuki Motorcycles:
"If your motorcycle is burning oil this indicates worn top end components. A leaking crank..."
Daniel MacDonald posted an answer for this Suzuki Motorcycles:
"My 1969 ts 250 is burning crank case oil. Must be the crankshaft seal is out? Can I replce..."
Daniel MacDonald posted an answer for this 2004 Yamaha YZ 125:
"The manafacturer of the piston you are going to use has a specefic piston to clyinder fit...."
Daniel MacDonald posted an answer for this 2004 Yamaha YZ 125:
"1 want to rebuild my top end its a stock cylinder is a 56mm piston ok to use or do i go..."
Daniel MacDonald posted an answer for this 1993 Suzuki VS 1400 Intruder:
"raise rear wheel off ground, remove axle, spacersand rear caliper. wheel assambley will..."
Daniel MacDonald posted an answer for this 2006 Hero Honda Splendor+:
"locate and repair short in wiring"
Daniel MacDonald posted an answer for this 2006 Husqvarna TC 510:
"check for leak at intake manafold, lean runnining condition may cause severe engine..."
Daniel MacDonald posted an answer for this 2005 Yamaha TT-R 125 E:
"try bike bandit (dot) com"