Speedracer70 posted an answer for this 2003 Mercury Grand Marquis:
"Check the fusible wiring link near the battery and fuse box. Sounds like it has burnt."
Speedracer70 posted an answer for this 1987 Mercury Grand Marquis:
"You need to attach a pressure gauge to the schrader valve and measure the fuel pressure..."
Speedracer70 posted an answer for this 2000 Mercury Grand Marquis:
"Hello Steve, From your post, "Finally had enough and stuffed a small block of wood..."
Speedracer70 posted an answer for this 1995 Mercury Grand Marquis:
"Sounds like the sensor has failed closed or the wire to the sensor has shorted to ground...."
Speedracer70 posted an answer for this 1984 Mercury Grand Marquis:
"I would buy a new wiring connector from a good auto parts store or ford."
Speedracer70 posted an answer for this 2000 Mercury Grand Marquis:
"Sounds like a bad IAC valve. This will throw no codes and will also pass a smoke test."
Speedracer70 posted an answer for this 2003 Mercury Grand Marquis:
"https://www.youtube.com/watch?v=keCaYdmG0m4"
Speedracer70 posted an answer for this 2004 Mercury Grand Marquis:
"check out this link https://www.youtube.com/watch?v=keCaYdmG0m4"
Speedracer70 posted an answer for this 1998 Mercury Grand Marquis:
"Yes, it can be tightened from the back."
Speedracer70 posted an answer for this Mercury Cars & Trucks:
"Sounds like a IAC (Idle air control problem). I would just replace this module as it is..."
Speedracer70 posted an answer for this Mercury Cars & Trucks:
"Sounds like a IAC (Idle air control problem). I would just replace this module as it is..."
Speedracer70 posted an answer for this Amazon Computers & Internet:
"Please call you bank and ask them to investigate."
Speedracer70 posted an answer for this Computers & Internet:
"When working with difficult vendors, I find it helpful to cancel the credit card used for..."
Speedracer70 posted an answer for this Power Computers & Internet:
"So leave the power cord plugged it as it needs power to work."
Speedracer70 posted an answer for this 2004 Ford Mustang:
"Perform a fuel pressure test. You need ~ 40 lbs + to run well. If Zero, check the inertia..."
Speedracer70 posted an answer for this 2004 Ford Mustang V6:
"I would suggest no. It's just a bump stop. When adding caster / camber kits or lowering..."
Speedracer70 posted an answer for this 2004 Ford Mustang:
"You can reuse the original one without affecting handling or performance. Its really a..."
Speedracer70 posted an answer for this 2004 Ford Mustang:
"There are 2 on each Bank or side of the Exhaust system. One in front of the converter and..."
Speedracer70 posted an answer for this Ford Cars & Trucks:
"The ABS motor is controlled by the computer. The function is different for 2 wheel vs 4..."
Speedracer70 posted an answer for this Ford Cars & Trucks:
"Have you been keeping up on the scheduled maintenance and tune ups are detailed in the..."
Speedracer70 posted an answer for this Ford Cars & Trucks:
"Check the Fuses and Relays."
Speedracer70 posted an answer for this Ford Cars & Trucks:
"Your shop is not honest or incompetent if they changed 3 transmissions and they only last..."
Speedracer70 posted an answer for this 2004 Ford F250:
"Worn Tires, tires out of balance, worn tie rod ends, worn ball joints to name a few. I..."
Speedracer70 posted an answer for this 2001 Ford F250 Super Duty Super Cab:
"Actually here is another TS Relay under the dashboard in the middle below the radio and ..."
Speedracer70 posted an answer for this Ford Cars & Trucks:
"Have you checked the Relays?"
Speedracer70 posted an answer for this 2002 Ford F250 Super Duty SuperCab:
"www2.dana.com/pdf/5326.pdf I believe you have a Dana 50 front axle. 2004 and up come with..."
Speedracer70 posted an answer for this 2001 Ford F250 Super Duty Super Cab:
"Check the chain in the transfer case."
Speedracer70 posted an answer for this Ford Cars & Trucks:
"I would examine the color of your transmission fluid first. Is it bright red or is it..."
Speedracer70 posted an answer for this 1998 Ford F250 SuperCab:
"Look under the hood in the large fuse panel on the fender well."
Speedracer70 posted an answer for this 1990 Ford F250:
"What Engine do you have?"