EXPERT ADVICE,NO NEED FOR 2ND OPINION
procom office solutions posted an answer for this NEC Office Equipment & Supplies:
"Switch on the projector in standby mode. press the HOLD button on the remote for 10..."
procom office solutions posted an answer for this Office Equipment & Supplies:
"it depends on the model of the projector! The projector has an internal temperature..."
procom office solutions posted an answer for this Sony Office Equipment & Supplies:
"Sony VPL DX 100 is a native XGA projector [1024x768] so if u connect to a PC that has..."
procom office solutions posted an answer for this InFocus Office Equipment & Supplies:
"connect VGA cable to ur projector and the other end to ur laptops vga generally newer..."
procom office solutions posted an answer for this Sony Projector Lamp for VPL-HS51:
"it could be due to an incompatible lamp which has blown once again or it could be due to a..."
procom office solutions posted an answer for this Sanyo PLC-XW200LMP XGA Projector Projector Lamp:
"Hi!You need to check the back side of the lamp housing on the inner side of the projector...."
procom office solutions posted an answer for this InFocus SP-LAMP-LP9 Projector Lamp for LP925, LP93:
"hi this lamp has a small lamp pcb with a chip on it. have u change the complete module or..."
procom office solutions posted an answer for this Coby 20" Flat Screen TFT LCD TV Monitor:
"hi if you monitor is old , it may be due to bad filter caps in the power supply..."
procom office solutions posted an answer for this Panasonic PT-AX200U Projector:
"HI YOU NEED TO REPAIR / REPLACE THE MAIN BOARD. THE SUPPLY TO THE LCD PANEL CIRCUIT BLOCK..."
procom office solutions posted an answer for this Epson EX 7210 LCD projector:
"There could be two reasons.1.the lamp life has come to an end.2.The ballast that powers..."
procom office solutions posted an answer for this Panasonic 2 Projector Lamp:
"These lamps come with a lamp timer chip.there is no need to reset the lamp. When you..."
procom office solutions posted an answer for this Panasonic PT-AX200U Projector:
"Its the most common poblem with the ax 100-200 projector.Many a times only the ballast..."
procom office solutions posted an answer for this Panasonic PT-AX200U Projector:
"how may hours has your lamp done? if you have crossed more than 1500 hours , u may need to..."
procom office solutions posted an answer for this Panasonic PT-AE8000U Full HD 3D Home Theater Projector:
"If u have installed the projector to the ceiling, u will see the image upside down. for..."
procom office solutions posted an answer for this Panasonic PT-AE700U Multimedia Projector:
"go to settings and select the computer mode instead of YPbPr the image from the computer..."
procom office solutions posted an answer for this Panasonic Pt f300u Lcd Projector Xga 600:1 4000 Lumens Enet 13.7lbs Auto PT F300:
"could be anything lamp that has done more than 5000 hours dust on the optics damaged /..."
procom office solutions posted an answer for this Panasonic PT-AE700U Multimedia Projector:
"the heat from the lamp has damaged your LCD panel you may need to service the projector..."
procom office solutions posted an answer for this Panasonic Office Equipment & Supplies:
"you need to clean dust filter and replace filter if required it depends on which model u..."
procom office solutions posted an answer for this Panasonic PT-AE3000U LCD Projector:
"If the Panasonic Logo comes and then the projectors turns off, the main board of the..."
procom office solutions posted an answer for this Panasonic PT-AE900U Multimedia Projector:
"already posted"
procom office solutions posted an answer for this Panasonic PT-AE900U Multimedia Projector:
"you need to check: the Vga cables if the image shown is that from a computer firstly check..."
procom office solutions posted an answer for this Panasonic PT-AX200U Projector:
"The main board of the projector needs replacement! not worth getting it replaced as it..."
procom office solutions posted an answer for this Panasonic PT-LB60NTU LCD Projector:
"check the lamp for any bubble like structure on the filament.if ok the ballast unit has to..."
procom office solutions posted an answer for this Panasonic PT-AE3000U LCD Projector:
"it depends after how long the temperature indication comes if it comes immediately as soon..."
procom office solutions posted an answer for this Panasonic PT-AE900U Multimedia Projector:
"after you connect the laptop and the image shifts to the right, press auto adjust on the..."
procom office solutions posted an answer for this Acer X110P:
"check the connector betwen the mainboard and the dmd board.mostly it is a loose..."
procom office solutions posted an answer for this Hitachi Performa CP-RS55 Multimedia Projector:
"switch off projector turn the projector upside down, u will find a netted plastic which..."
procom office solutions posted an answer for this ViewSonic PJD5123 3D Projector:
"can u clarify whwat u are trying to do i assume u are trying to convert HD digital video..."
procom office solutions posted an answer for this Office Equipment & Supplies:
"not clear what is the problem u are reporting if it is showing replace the bulb in the..."
procom office solutions posted an answer for this Optoma GT700 Projector:
"DMD chip needs replacement get it replaced from technician"
procom office solutions posted an answer for this Panasonic PT-AE700U Multimedia Projector:
"open the bulb assembly and check if the bulb has fused / broken into pieces.if not then..."