Sal De posted an answer for this Jenn-Air Ovens:
"whenever you set an oven it always starts at 100,if that's an electric oven most likely..."
Sal De posted an answer for this Kenmore Dryers:
"yes,unplug it,get a putty knife and slide it under the top control panel on each..."
Sal De posted an answer for this Maytag Dryers:
"http://homeguides.sfgate.com/replace-broken-baffles-frontloading-washing-machine-104577.ht..."
Sal De posted an answer for this Kenmore Ovens:
"that model doesn't come up,that could be the serial number,do you know that when the dryer..."
Sal De posted an answer for this Kenmore 24 in. 15689 Built-in Dishwasher:
"If the clean light flashes 7 times it's an error code telling you that there's a heat..."
Sal De posted an answer for this Kenmore Dishwashers:
"If the clean light flashes 7 times it's an error code telling you that there's a heat..."
Sal De posted an answer for this Kenmore Dishwashers:
"there's a thermal fuse that can pop if it won't run or no lights,if you have power in the..."
Sal De posted an answer for this KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher:
"if the light is flashing 7 times there's a heat problem and the dishwasher won't start,if..."
Sal De posted an answer for this Dishwashers:
"remove the bottom kick panel,you'll see a tech sheet there in the plastic bag,it will tell..."
Sal De posted an answer for this Dishwashers:
"yes you reset the board but after like 7 loads it's gonna do it again,that's an error..."
Sal De posted an answer for this Dishwashers:
"the flashing light is an error code,you either have a bad heater or the board is bad,once..."
Sal De posted an answer for this KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher:
"even though you reset the board the flashing light is an error code,you either have a bad..."
Sal De posted an answer for this KitchenAid 24 in. KUDP01FL Built-in Dishwasher:
"if it ran for 2 minutes most likely it went into cancel drain just like when you hit the..."
Sal De posted an answer for this LG DLE2101 Electric Dryer:
"you can buy a new block and you don't have to replace the whole harness if the wire just..."
Sal De posted an answer for this Electrolux Dryers:
"these machines have alot of computer board issues,unplug the dryer,go in the back where..."
Sal De posted an answer for this Maytag Dryers:
"this is an electric dryer,first thing to do is on the back where the cord connects to the..."
Sal De posted an answer for this Whirlpool Dryers:
"that could be a few different things ,broken belt,there's a switch on the belt pulley that..."