Press enter to search.
Bernina Gal with a passion for saving vintage sewing machines
R.A. Ellis posted an answer for this Husqvarna Viking Emerald 116 Sewing Machine:
"Use a zig-zag so the stitching will not pop when the fabric stretches."
R.A. Ellis posted an answer for this Sewing Machines:
"Please explain your situation more fully. Is the fabric puckering where you stitch, or is..."
"It is probably best to just purchase a brand new one. Trying to fix it may or may not be..."
"Set the stitch width to zero."
R.A. Ellis posted an answer for this Janome Sewing Machines:
"Sounds like your machine needs service for an adjustment."
R.A. Ellis posted an answer for this PfaFF Sewing Machines:
"Contact your dealer."
R.A. Ellis posted an answer for this Bernina Sewing Machines:
"Page 5 of the manual. #32
"If it's a mechanical machine, most likely the stitch width mechanism is frozen due to old..."
"The factory default is the midway point between high & low numbers on each of the..."
"If the needle is not centered over the hole when set on a straight stitch, your machine..."
"Try a brand new needle and verify it is threaded correctly. If that doesn't help, it..."
"With the error message and needle problem, you should probably take it for service."
"If it is a mechnical machine (not computerized). Possibly the dial mechanism is stuck due..."
R.A. Ellis posted an answer for this Husqvarna Sewing Machines:
"Sounds like the thread sensor is dirty or defective."
R.A. Ellis posted an answer for this Brother Sewing Machines:
"You need to set the seam guide (or whatever you are using) to be 1/4" away from the..."
"Not sure what is your question, but this may help.
Sewing Presser Feet"
"Try the correct category--not a sewing machine."
"If you are free motion quilting, you are manually moving the fabric while the machine..."
"This will help you figure it out:
Sewing Presser Feet"
R.A. Ellis posted an answer for this Singer Sewing Machines:
"Loosen the top tension and lengthen the stitch length all the way Then sew two lines of..."
"The top tension is intended to be adjusted for different uses and on different fabrics. ..."
"Sounds like the needle bar is slightly off center. Take it for service."
"Increasing the top tension (and possibly decreasing the bottom tension) will cause the top..."
Make Model accessories"
"Sounds like it may be the density or the material in the badges interfering with the..."
"Perhaps the bobbin thread sensor is dirty."
"Usually, you can find replacements at a dealer for your machine's make & model, or try..."
"Might try a different presser foot. Could be the machine is not reading the current..."
"Depends what E1 means for your machine model. On a lot of machines, it means it is..."
"Probably no resolutions posted on the sewing machine query site."
"You probably need to tighten the upper tension. The tension is correct when the top and..."
Load more activity...
1,216,602 people helped
View all achievements