Gerry posted an answer for this BMW Cars & Trucks:
"What model is your bmw But on most of them its on the top front timing cover or on the..."
Gerry posted an answer for this 1997 BMW 328:
"behind the glove box"
Gerry posted an answer for this 1997 BMW 3 Series:
"remove the fan motor cover and check the wires on the fan motor 99%chance that one is..."
Gerry posted an answer for this 1997 BMW 328:
"remove the left kick panel it is located on the heater housing and hel in by 3 screws easy..."
Gerry posted an answer for this 2000 BMW 3 Series:
"those IHKA (heater control unit inside car) units have a bad habit of failing try the..."
Gerry posted an answer for this 1995 BMW 3 Series:
"BMW will be able to help you unless it is a aftermarket fitment witch any good sparky..."
Gerry posted an answer for this BMW Cars & Trucks:
"when was the last oil change done and has the correct oil been used i have had m52tu..."
Gerry posted an answer for this 1994 BMW 3 Series:
"need more info or take it to BMW"
Gerry posted an answer for this 1999 BMW 3 Series:
"under the right side of the boot lid is a wire-ring loom that has a green wire with a pink..."
Gerry posted an answer for this 2004 BMW 3 Series:
"break left hand rear window (its the cheapest ) or get BMW to open car will cost the same"
Gerry posted an answer for this BMW Cars & Trucks:
"need more info - year model 16v or 8v cam chain or belt"
Gerry posted an answer for this BMW Cars & Trucks:
"make sure that the filler cap seal is in place and not gone hard over time also has the..."
Gerry posted an answer for this BMW Cars & Trucks:
"some of the micro switches may have moved and lost contact Lift the base of the rear seat..."
Gerry posted an answer for this BMW Cars & Trucks:
"there is a special procedure that needs to be done with the DIS machine see BMW for..."
Gerry posted an answer for this 2003 BMW 3 Series:
"make shore that your timing is 100% use correct cam locks(can be obtained from tool..."
Gerry posted an answer for this 2007 BMW 750Li Sedan:
"check all fuses in the trunk and behind the glove box other than that seek help from BMW..."
Gerry posted an answer for this 2004 BMW 7 Series:
"no only the cam timing can be adjusted and to do this you need the correct cam locks and..."
Gerry posted an answer for this 2005 Yamaha YZF-R1:
"check the compression if its low rebuild engine"
Gerry posted an answer for this 2004 Yamaha YZ 250 F:
"contact Yamaha dealer parts department is the best bet"
Gerry posted an answer for this 1992 Yamaha XJ 600 Diversion S:
"have a look at your breather hose that is located on the top of the clutch housing and see..."
Gerry posted an answer for this 2009 Yamaha Zuma 125:
"remove the spark plug and install a screw in type compression tester ,isolate the HT lead..."
Gerry posted an answer for this 1997 Yamaha YZF 600 R thunder cat:
"have a look at the meshing faces of the gears if they are worn they need to be undercut..."
Gerry posted an answer for this 2008 BMW 3 Series:
"Sorry mate take it to BMW if you don`t have the ETM DON`T make it harder for yourself..."
Gerry posted an answer for this BMW Cars & Trucks:
"see your owners manual and your phone manual to pair the 2 units or get the guys from your..."
Gerry posted an answer for this BMW Cars & Trucks:
"on the front of the engine in the middle just under the intake manifold"
Gerry posted an answer for this 2001 BMW X5 3.0i:
"99% bet on the left hand front cv joint"
Gerry posted an answer for this 2004 BMW 325i:
"remove the expansion tank and have a look at the seams those tanks have a habit of..."
Gerry posted an answer for this Motorcycles:
"if its the screw @the back with the spring I would guess that there should be a O-ring of..."
Gerry posted an answer for this 1984 Honda GL 1200 Aspencade Gold Wing:
"0.7-0.9mm"
Gerry posted an answer for this 2002 Honda XR 200:
"worn out bore ,broken rings burnt piston best is to pull the head of and check"
Gerry posted an answer for this Motorcycles:
"check all your fuses and then check your dash bulbs and replace as needed"