jren posted an answer for this 2003 Harley Davidson XL 1200 C Sportster Custom:
"First, where does it come from. It is the overflow for the carb. Comes from a tube inside..."
jren posted an answer for this Motorcycles:
"Right side, lower rear? Its oil level. Yes there should be a level."
jren posted an answer for this 2005 Honda FSC 600 S:
"I would first suspect the stator. you need to have an ohm meter and ohm out the stator..."
jren posted an answer for this 2006 kawasaki Vulcan 1600 Nomad:
"OK officially you are supposed to measure oil height. Oil quantity is not quite right..."
jren posted an answer for this Motorcycles:
"it is the torx bit on the bottom of the primary drive. towards the back.exactly at 6 o..."
jren posted an answer for this Harley Davidson Motorcycles:
"sounds like gas tank vent is clogged. instead of pulling over or letting idle unscrew..."
jren posted an answer for this 2003 Harley Davidson XL 1200 C Sportster Custom:
"Sorry to say pretty hard to find them online. Harley is pretty vigilant about chasing..."
jren posted an answer for this 2000 Yamaha Xv 250 Virago S:
"well, the trans feels like 4 taller gears because with your sprocket change you changed..."
jren posted an answer for this 2006 Harley Davidson XL 1200 L Sporster Low:
"Spark Plug wire? Just pull it. it will pop off."
jren posted an answer for this Motorcycles:
"air leak between carbs and motor. you can test by squirting carb cleaner on the intake..."
jren posted an answer for this Motorcycles:
"remove the right side clutch cover. remove shifter. remove entire clutch assy. remove..."
jren posted an answer for this 2001 Harley Davidson FLHR - FLHRCI Road king:
"you'll find that the little rivet on the right side came out. best bet is to buy a new..."
jren posted an answer for this Motorcycles:
"Any dealership you visit will try and sell you a new tire because of the liability of..."
jren posted an answer for this Motorcycles:
"don't know the specs off the top of my head but you need a specail tool that fits in place..."
jren posted an answer for this Motorcycles:
"you should have a decompression lever and cold start lever. you pull the decompression..."
jren posted an answer for this Suzuki Motorcycles:
"You need to get a manual for your bike...you should have adjustment behind the clutch..."
jren posted an answer for this 1999 Suzuki VS 1400 Intruder:
"you need to perform a wet and dry compression test. could be nackered rings or valves. ..."
jren posted an answer for this 2003 Yamaha YZ 250 F:
"you need to pull the top cover and see if the chain is off. unless the cam chain is..."
jren posted an answer for this 2003 Harley Davidson FLHR Road king:
"Have you had the clamps apart to see if they are actually stripped? Sometimes you can..."
jren posted an answer for this 2000 KTM EXC 300:
"DON'T SLEEVE. It is almost as cost effective to have the cylinder welded and re..."
jren posted an answer for this 1983 Suzuki Gs 550 L:
"What have you done if anything to check out this problem? Several causes could be: 1...."
jren posted an answer for this 2005 Harley Davidson FLHRS - FLHRSI Road King Custom:
"Backfiring on decel is caused by lack of back pressure. Makes sense as your batting is..."
jren posted an answer for this 2003 Pontiac Grand Am:
"Let me get the problem straight. You replaced the thermostat with one not designed for..."
jren posted an answer for this 2002 Chevrolet Astro:
"you could shotgun both parts and replace both...or just remove the thermostat. place it..."