2
John In Milford posted an answer for this Home:
"This is either the 'lock end switch' or the computer. You can usually disconnect the..."
John In MilfordJohn In Milford posted an answer for this Home:
"You used the correct verbiage. However if none of the lights work, it's very possibly the..."
John In MilfordJohn In Milford posted an answer for this Chime Home:
"A worn chime cog wheel will not reset or advance the count. Unless you're good at making..."
John In MilfordJohn In Milford posted an answer for this Chime Home:
"Take off the little nut that holds the minute hand and remove the hand, place it back on..."
John In MilfordJohn In Milford posted an answer for this Home:
"Lo batteries or too far away or interference will cause this."
John In MilfordJohn In Milford posted an answer for this Home:
"Someone moved the hour hand, probably when changing the daylight saving time. The minute..."
John In MilfordJohn In Milford posted an answer for this Home:
"Try changing the channel switch on both units, you're likely getting interference. If..."
John In MilfordJohn In Milford posted an answer for this Glacier Bay Home:
"Check around the back for a reset button, this is caused by running the water too low. If..."
John In MilfordJohn In Milford posted an answer for this Home:
"If only on the ¼ hour, but not on the others, there's a worn or chipped geartooth. If All..."
John In MilfordJohn In Milford posted an answer for this Home:
"To Set the DST and TIME ZONE Press and hold the SET/WAVE button for couple of seconds and..."
John In MilfordJohn In Milford posted an answer for this Seth Thomas Home:
"Sounds like someone moved the hour hand! Put the hour hand back by gently turning it to..."
John In MilfordJohn In Milford posted an answer for this Home:
"Tell us the make and model in order for us to know what we're dealing with."
John In MilfordJohn In Milford posted an answer for this Home:
"Unfortunately, I have heard that complaint several times and there's nothing you can do..."
John In MilfordJohn In Milford posted an answer for this Home:
"The control assembly in the tank is faulty. Type "M-1011526-F3" into google search and the..."
John In MilfordJohn In Milford posted an answer for this Home:
"Be sure that the rubber gasket on the fill assembly is installed INSIDE the tank, NOT..."
John In Milford
John In Milford posted an answer for this Computers & Internet:
"Go to https://mail.google.com If you're logged in, you'll go right to your inbox, if not..."
John In Milford
John In Milford posted an answer for this Heating & Cooling:
"It sounds like you have replaced the fan motor. If so and it has 2 brown wires, you need..."
John In Milford
John In Milford posted an answer for this Motorola Radio Communications:
"New batteries are needed if the 'recondition cycle either : Doesn't correct the problem,..."
John In Milford
John In Milford posted an answer for this Craftsman 19.2V C3 DRILL/DRIVER:
"Generally, if you remove the battery and leave it in the charger over night, the internal..."
John In Milford
John In Milford posted an answer for this Hotpoint Washing Machines:
"Unplug for 30 minutes to reset the control board. If problem persists, it is likely that..."
John In Milford
John In Milford posted an answer for this Daihatsu Cars & Trucks:
"Check to see where to closest Auto Parts place that will scan it for you is. Not worth it..."
John In MilfordJohn In Milford posted an answer for this Cars & Trucks:
"Sounds like you replaced a lot of expensive parts when it was probably the shifter switch..."
John In MilfordJohn In Milford posted an answer for this Washing Machines:
"Many times it's that the unit hasn't drained completely, Check the drain hose from the..."
John In Milford
John In Milford posted an answer for this GE Spectra JBP78 Electric Kitchen Range:
"Try setting the oven to [CLEAN] Then after 2 Minutes check to see that the door has..."
John In MilfordJohn In Milford posted an answer for this Cars & Trucks:
"Get to an auto parts store. Most will scan your car fro free. You likely find that the..."
John In Milford
John In Milford posted an answer for this 2002 Chevrolet Impala:
"It's quite possible that the oxygen sensors were fouled by something that got into the gas..."
John In Milford
John In Milford posted an answer for this Dewalt DW735 13 Inch 2 Speed Planer With 3 Cutters:
"Common problem. As long as the chip/dust doesn't impede the dust collection or interfere..."
John In Milford
John In Milford posted an answer for this Ovens:
"That unit's fan should run as long as the unit is in any heating cycle."
John In Milford
John In Milford posted an answer for this HP Office Equipment & Supplies:
"USUALLY caused by high volume of pages, or being left idle for very extended periods. If..."
John In Milford
John In Milford posted an answer for this Freeplay Energy Summit AM/FM/SW Radio:
"With a lot of use, the capacitors wear out. They basically work like a battery, they can..."
John In MilfordJohn In Milford posted an answer for this Electrolux Washing Machines:
"Check your drain hoses. All the way from the drain pipe of the house back all the way to..."
John In Milford
Cars & Trucks 32 answers
Refrigerators 30 answers
Televison & Video 26 answers
Home 16 answers
Computers & Internet 12 answers
Audio Players & Recorders 11 answers
Washing Machines 10 answers
Office Equipment &... 6 answers
Heating & Cooling 6 answers
Kitchen Ranges 6 answers
