Jim Chinnery posted an answer for this Whirlpool Washing Machines:
"Open the door, put your hand in and onto the top of the inner drum. Push upwards, if it..."
Jim Chinnery posted an answer for this Maytag Washing Machines:
"Did it fill with water? If it did it's probably the motor brushes, they normally last..."
Jim Chinnery posted an answer for this Speed Washing Machines:
"Does it sound like the motor is running? If it is could be the belt slipped off or broken."
Jim Chinnery posted an answer for this Maytag Washing Machines:
"Have you cleaned the large drive belt, if it slips it could cause this sort of fault...."
Jim Chinnery posted an answer for this Kenmore 24082 Top Load Washer:
"There should be a large drain plug on the bottom front right hand side. Unscrew it and..."
Jim Chinnery posted an answer for this Washing Machines:
"If the machine will wash but not spin it's the drive belt slipping because it needs..."
Jim Chinnery posted an answer for this Kenmore Washing Machines:
"Almost every machine I've seen that doesn't washes but doesn't spin had the same problem,..."
Jim Chinnery posted an answer for this Vivitar Cameras:
"Had the same problem with three cameras, dirty or tired connections. They switched on..."
Jim Chinnery posted an answer for this Sherwood Audio Players & Recorders:
"The buzz is probably caused by bad earthing,If the earth return is through screws holding..."
Jim Chinnery posted an answer for this Washing Machines:
"Check for water leaks, I've had 2 of these both with motor faults caused by leaks one..."
Jim Chinnery posted a question about Washing Machines:
"Was dead no lights, replaced PCB module lights came on tried to use the washing machine..."