Jim Verge posted an answer for this Radio Communications:
"For what radio?"
Jim Verge posted an answer for this Cobra Radio Communications:
"You may have blown out the output transistor in the CB. Can you still calibrate the swr..."
Jim Verge posted an answer for this Radio Communications:
"Is it a Pinto SSB, Pinto 23 or Pinto Jr?"
Jim Verge posted an answer for this Radio Communications:
"Just in front of VR 18 Nearer to the back panel of the radio about half way across the..."
Jim Verge posted an answer for this Radio Communications:
"Sounds like the Final Output transistor may be blown. You'll have to replace it or bring..."
Jim Verge posted an answer for this Cobra 29 LTD CB Radio:
"William Clayton is correct. If you haven't soldered on delicate electronic devices and..."
Jim Verge posted an answer for this Galaxy Radios DX 959 SSB CB Radio:
"Can you hear other stations that are farther away on the Galaxy? If so, the receiver is..."
Jim Verge posted an answer for this Cobra Radio Communications:
"Technically, YES! The Cobra 29 Sound Tracker "COULD" be converted to 10 meter Ham radio..."
Jim Verge posted an answer for this Galaxy Radios DX-44V 40-Channels Base CB Radio:
"Carefully check the Colector Voltage on the Final and the driver during transmit. Use the..."
Jim Verge posted an answer for this Galaxy Radios DX-2517 CB Radio:
"Do you have output on Single Sideband? If you do, your AM Regulator Transistor and/or..."
Jim Verge posted an answer for this Ranger Communications RCI-6900F-25 CB Radio:
"Check the service manual to find out what the VCO Voltage should be. I'm guessing it..."
Jim Verge posted an answer for this Ranger Communications RCI-6900F-25 CB Radio:
"The 2990 is a base station and it would be tough to hook it up "backward". You either have..."
Jim Verge posted an answer for this Ranger Communications RCI-6900F-25 CB Radio:
"Though those radios are "Marketed" as "10 Meter Ham Radios" (Wink Wink) they were and are..."
Jim Verge posted an answer for this Cobra 78x 40 Channel Cb Radio With Microphone Dukes Of Hazzard General Lee:
"Can you be a little more specific with your question."
Jim Verge posted an answer for this Magnum DeltaForce CB Radio:
"1= White/Audio 2=Black/Receive 3=Blue/Transmit 4=No Connection Pin 4 is the up down..."
Jim Verge posted an answer for this Radio Communications:
"Here's the other half"
Jim Verge posted an answer for this Radio Communications:
"Here is half of it"
Jim Verge posted an answer for this Radio Communications:
"Balanced modulator of SSB mic amp."
Jim Verge posted an answer for this Radio Communications:
"Bad mic wire? Does it happen if the radio has been in use for awhile or does it happen all..."
Jim Verge posted an answer for this Radio Communications:
"There is no adjustment to turn up the carrier power in a Cobra 25 LTD. The AM Cobra's are..."
Jim Verge posted an answer for this Galaxy Radios Microsystems DX33HP CB Radio:
"You're probably savvy with radios so don't get mad if I ask you to check the PA Button. If..."
Jim Verge posted an answer for this Radio Communications:
"Overheating MOSFET(s) Output Final(s) or bad voltage regulator. The Strykers are noted for..."
Jim Verge posted an answer for this Cobra ELECTRONICS 29-LTD Cb Radio - 29 Ltd Classic:
"You are at a point where you should send it to a shop. That's the best advice I can give..."
Jim Verge posted an answer for this Radio Communications:
"Pinning? Do you mean it's feeding back/squealing through the speaker? Turn the mic gain..."
Jim Verge posted an answer for this Radio Communications:
"It isn't legal to do so but some people do."
Jim Verge posted an answer for this Radio Communications:
"What radio are you asking about?"
Jim Verge posted an answer for this Radio Communications:
"I couldn't find anything either. :-("
Jim Verge posted an answer for this Radio Communications:
"VR 14 for AM and VR 12 for SSB. I wouldn't mess with FM or you could end up with over..."
Jim Verge posted an answer for this Uniden 2SC1973 Transistor for Grant and Cobra 148 XLT Radios:
"Wrong Microphone, Shorted leads in the microphone plug or a bad transmit switching..."