icorella posted an answer for this 2001 Ford Windstar:
"The blender door actuator, the one that most commonly fails on Windstars, is located..."
icorella posted an answer for this 2001 Ford Taurus:
"www.gates.com"
icorella posted an answer for this Cars & Trucks:
"You have either a faulty electronic actuator or needs to be calibrated. Let me know if you..."
icorella posted an answer for this 2003 Ford Focus:
"In front of the passenger side wheel. You have to remove the cover."
icorella posted an answer for this 1999 Ford Taurus:
"Your problem is a faulty heater control valve. The design used on these vehicles allows..."
icorella posted an answer for this 2000 Pontiac Montana:
"Low refrigerant charge or a sticking blender door. Check the suction line for temperature...."
icorella posted an answer for this 2001 Ford Windstar:
"http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7009"
icorella posted an answer for this 1994 Honda Civic Del Sol:
"Low side acces (A/C) is in the suction tube, between the compressor and the firewall..."
icorella posted an answer for this 1999 Lincoln Continental:
"The problem is causes by a broken vacuum line. These lines are all over the engine..."
icorella posted an answer for this 1997 Chevrolet K1500:
"It is a major job. The dashboard must be loosened and sided out to get the HVAC module out..."
icorella posted an answer for this 1997 Chevrolet Cavalier:
"Your compressor's shaft seal is the most likely culprit. If you can find someone to..."
icorella posted an answer for this 2003 Toyota Corolla:
"First, you have to check if there is enough gas in the system in order to make the..."
icorella posted an answer for this 2001 Ford F150 Styleside SuperCrew:
"You have to remove the center dashboard bezzel out. Is held in place by pressure stubs..."
icorella posted an answer for this 1997 Ford Econoline:
"Defrost is the default mode when there is no vacuum. Look by the passenger side under the..."
icorella posted an answer for this Heating & Cooling:
"The most common cause is a disconnected or broken vacuum line in the vacuum reservoir, a..."