Frank Cole posted an answer for this Radio Communications:
"This usually indicates you are entering a frequency outside of the radios range. be sure..."
Frank Cole posted an answer for this Radio Communications:
"Run the Baofeng software that came with the program cable then download the Chirp..."
Frank Cole posted an answer for this Uniden Radio Communications:
"Press scan then press key pad numbers to enable banks. All of your programmed frequencies..."
Frank Cole posted an answer for this Radio Communications:
"Check that R-DCS is off."
Frank Cole posted an answer for this Miscellaneous:
"Turn off the device. Press and hold the Volume Up key and the Home key, then press and..."
Frank Cole posted an answer for this Cell Phones:
"There are likely apps running in the background all the time. Make sure you terminate any..."
Frank Cole posted an answer for this Radio Communications:
"It is a direct entry scanner so just enter manual and program then enter the frequencies..."
Frank Cole posted an answer for this Radio Communications:
"I have only done the UV5 series but I believe it is the same procedure. If using chirp,..."
Frank Cole posted an answer for this Radio Communications:
"Verify the offset is correct. Was it programmed with chirp or another software. Transmit..."
Frank Cole posted an answer for this Mach Speed Trio Stealth G2 8 inch Tablet with 8GB Memory:
"I have not seen this model listed with built in Bluetooth. You could add a USB bluetooth..."
Frank Cole posted an answer for this Mach Speed Trio Stealth G2 8 inch Tablet with 8GB Memory:
"If you can power it on go into settings then backup and reset. This will reset tablet to..."
Frank Cole posted a question about Mach Speed Trio Stealth G2 8 inch Tablet with 8GB Memory:
"Did factory reset and still not working. The tablet works fine except about 2" from one..."